TPS setting voltage or Rover Gauge

[Robbo D]

Hi all.

Just setting my TPS and this time did it by voltage with a multi meter. Setting it to 0.32v as numerous posts have mentioned I.e between 0.32-0.34v. RG is showing a reading of 4% absolute and 0% corrected. Advice please

Rob

[blaze_away]

I'll check my database but frommemory that sounds spot on.

[Belle427]

Info here.
https://www.pistonheads.com/gassing/topic.asp?h=0&...

[Robbo D]

Belle427 said:

Info here.
https://www.pistonheads.com/gassing/topic.asp?h=0&...

Hmm. Not really sure on this info.

Typically a throttle pot that is adjusted correctly will go from 5% to 97% corrected range. It should not drop below 2% minimum or the ECU may throw a fault code saying the T.P. is out of range.

My Rover Gauge shows corrected range as 0% to 97% and 4% absolute. To get the figures above would need the voltage to be at to approx 0.65 volts.

Rob

[Belle427]

I was under the impression the absolute setting was the one to watch, as long as the percentages match the recommended i would just leave it alone and move on.

[Robbo D]

If absolute is the one to take note of then all is good with my TPS nice and smooth through the range as well.

Rob.

[Belle427]

Perhaps absolute is what the Tps is set to and corrected what the Ecu sees?