NEFF integrated dishwasher issue

[LaserTam]

About 18mths old and the red tap symbol has appeared which manual suggests a supply problem. It does have an aquastop fitted. Troubleshooting manual suggests checking
- clean filter on the aquastop - done, nothing in there
- supply tap for limescale etc - no issue there, ran the tap without the supply connected
- kink in the supply pipe - nope

Any other suggestions of things to check? I've tried the traditional switch off at the wall and back on, in case it cleared an aqastop blip, no change. I'm assuming I would see a different fault if there was any pump out blockage or leak?

[Baldchap]

Does anything come out of the end of the supply pipe if you disconnect it?

If the answer is yes it sounds like a warranty job. Neff service and repair are really good.

[LaserTam]

Baldchap said:

Does anything come out of the end of the supply pipe if you disconnect it?

If the answer is yes it sounds like a warranty job. Neff service and repair are really good.

From the isolator on the supply, yes it does. I do have an extension supply pipe, then the aquastop. Water comes out from the extension pipe too. So does suggest an issue with the aquastop.

[LaserTam]

LaserTam said:

Baldchap said:

Does anything come out of the end of the supply pipe if you disconnect it?

If the answer is yes it sounds like a warranty job. Neff service and repair are really good.

From the isolator on the supply, yes it does. I do have an extension supply pipe, then the aquastop. Water comes out from the extension pipe too. So does suggest an issue with the aquastop.

I've booked a warranty repair for later in the week.

[heisthegaffer]

I had this on a really old Bosch, it was actually where the bottom tray had some water in. We let it dry and then tipped it and this resolved the issue.

Appreciate you'll be sorted OP but FYI for anyone