Db9 2005 drivers window goes up and down on steps

[mike-2txrc]

I have an issue with the DB9 drivers window.

I have tried the window reset but it still goes up and down on steps and doesn't drop when you open the door.

Anyone else had this? I've seen on one post, remove fuse 83 and it resets the door module?

Cheers

[Simpo Two]

mike-2txrc said:

I have tried the window reset but it still goes up and down on steps and doesn't drop when you open the door.

Anyone else had this? I've seen on one post, remove fuse 83 and it resets the door module

It does, but 'steps' sounds like a mechanical issue.

The early window modules get a bit flaky over time and can lose their memory. The fuse trick can restore them but they'll still go wrong again later. Mine have both been reset many times! They can be replaced with later modules if it bothers you too much.

[ian448]

The circuit board on the window regulator has gone , there prone to water ingress which causes the issue. Its either a new window regulator or there is a ebayer who occasionaly lists offering a circuit board repair service for £75.

[mike-2txrc]

Cheers all.

I will try the fuse trick first and see what happens but it may end up being a replacement or repair job.

Thank you.

[4.7AMV8]

mike-2txrc said:

Cheers all.

I will try the fuse trick first and see what happens but it may end up being a replacement or repair job.

Thank you.

My Vantage did the same. It was water in the circuit board.