Porcelain core drill
Author
Discussion

anonymous-user

Original Poster:

81 months

Wednesday 29th April
quotequote all
I need to drill through a 20mm porcelain slabs. Will this do it or do I need a specialist but?
Thanks

cliffords

3,991 posts

50 months

Wednesday 29th April
quotequote all
I did a sink with a tool similar to that . It was a tap hole .
The one I used looked finer with visible diamond chips on it .
It would have been from Screwfix but not their own brand .
I can look tomorrow if you want.

I used water and sweated a bit as the sink was £500. It cut it very cleanly in the end

Edited to add. It was called a wet diamond core drill

hidetheelephants

35,168 posts

220 months

Wednesday 29th April
quotequote all
Should do, diamonds are diamonds, they don't come in soft and hard.

Vanden Saab

17,665 posts

101 months

Friday 1st May
quotequote all
You may get away with it depending on the grade of the porcelain but it is likely to chip the tile. If that is not a problem go for it. However if you want the proper tool for the job use something like this which runs off an angle grinder.

https://www.travisperkins.co.uk/diamond-core-bits/...

Top tip with these dry cut drills have a bucket of cold water next to you and dip the drill in it regularly to keep it cool. It will drill better and the bit will last 5 times as long.

ashenfie

2,950 posts

73 months

Friday 1st May
quotequote all
I have the erbauer version of the works well. Use with water and they don’t last long so go carefully.

anonymous-user

Original Poster:

81 months

Saturday 2nd May
quotequote all
Intended up cutting it with the tile cutter in the end. It was taking an absolute age to even drill a pilot hole

reggie747

281 posts

154 months

Sunday 3rd May
quotequote all
The old trick off fining the back of the hole position with a thin diamond blade.
That leaves a lot less for the bit to cut through.
And yes, as you've since discovered, it's a slow careful job.

anonymous-user

Original Poster:

81 months

Sunday 3rd May
quotequote all
Would there be anyone that could use a commercial drill to drill me a perfect hole? What sort of place would do that, I'm thinking granite worktop type of place maybe? I've cut the tile now but do have a few spare so would possibly get it drilled professionally.

RotorRambler

1,260 posts

17 months

Sunday 3rd May
quotequote all
Could try a professional tiler, pay for their time.

When I did my bathroom (large format porcelain tiles) the tile shop suggested I do that if I got stuck.

I did mine in the end, nightmare, never again!