Fuel hoses

[Harvy500]

Took my Griffith out as it was a nice day.
Half way to my destination, the fuel needle dropped and went down steadily.
Arrived and took a look. What a mess!!
The fuel hose that runs out of the fuel filter then runs all the way to the front of the car.
It was that one that let go APPX 50mm from the jubilee clip filter outlet. To get it home it pulled the outlet of the filter, cut off the part that popped a hole and put that directly on the outlet of the fuel pump. I basically had to temporarily delete the fuel filter. Not ideal but it got my car home and it drove as it always does.
Allegedly all hoses were replaced while other work was done on my car.
The hoses are not in great condition so I'm going to get some quality ethanol safe hoses.
I'll change all I can.
As for the 2 hoses that run all the way from the back to front, mine are the same rubber hose.
Would it be worth replacing the 'long hoses' with metal pipe? Brass? Stainless steel? Copper?
Seems like my cars going to be off the road for a while.

[BritishTvr450]

Ordinarily they should be copper as they run along the chassis then return to rubber just above the gearbox.

[Loubaruch]

As Alun says they were originally copper but I found that all my fuel leaks were at copper/rubber joints so chose to completely eliminate any metal/rubber joints on the high pressure feed. The return to the tank is low pressure so copper/rubber joints are not a problem.

If you have not seen this it may help:

https://www.bertram-hill.com/replacing-the-fuel-li...