Shower issues

[Race2the Redline]

While investigating some sticking buttons on a Mira shower (looks like it was installed too tight on a fractionally uneven surface causing it to warp)

I've found this less than ideal gap around the pipework that looks like a future issue, given I don't want to over tighten it again and trust the existing gasket I'd love some advice on the best course of action please

• Simply put some sealant on the back of the shower plate?
• Make a template to fill the gap and seal it in?
• Some sort of waterproof collar over the hole?

Edited by Race2the Redline on Friday 30th October 10:40

[davek_964]

It reads as if there should be a picture......

[Race2the Redline]

davek_964 said:

It reads as if there should be a picture......

You're absolutely right, fell foul of the 10mb limit!

[Belle427]

Just use a good quality sealant, as long as the water is kept out of there it will be fine.

[Race2the Redline]

Thanks, think I'm being paranoid having had a couple of leaks in the same week.