Adjusting UPVC Butt Hinges
Discussion
Can these UPVC door hinges be adjusted so that there is less compression on the hinge side?
I fitted a new universal seal to the door and there is too much pressure on the hinge side which is creating a gap at the bottom on the latch side and you have to push hard to close the door.
I’m yet to fit the internal seal (as can be seen in the photos) so I imagine it’s only going to get tighter if I do. I might have to get a thinner seal if it’s not adjustable.
It turns out you can adjust the compression with the Allen key slot on the top.
The top hinge adjusted perfectly but unfortunately the middle and bottom ones will not budge. And now to add to it I removed the hinge pin on the central hinge and now I can’t get it back in. It has one flat edge so I’m guessing it’s got to go in the correct orientation on the 360° axis…??
Gassing Station | Homes, Gardens and DIY | Top of Page | What's New | My Stuff


