Putting a Cd-changer in a 996 that doesn't have one
Putting a Cd-changer in a 996 that doesn't have one
Author
Discussion

magriggs

Original Poster:

875 posts

249 months

Thursday 20th October 2005
quotequote all
Chaps, is it possible to put a proper Porsche CD-changer into a 996 if it didn't leave the factory with one? I remember that my last car came "ready for CD changer" as standard, although you still had to pony up two hundred quid for one :-)

If not, I guess I'll have to look into an after-market solution. Any recommendations on hi-fi dealers/fitters?

A3Targa

98 posts

249 months

Thursday 20th October 2005
quotequote all
Sextons of Wandsworth in London are excellent...

cyrus1971

855 posts

266 months

Friday 21st October 2005
quotequote all
Yes the believe the wiring is pre-run to the front in Boxster / 996 etc. I think the standard Porsche branded 6 CD changer is actually a Becker Silverstone - save yourself a few £. I rate sextons too.

magriggs

Original Poster:

875 posts

249 months

Friday 21st October 2005
quotequote all
Brilliant, thanks for the info :-)

Denis O

2,141 posts

270 months

Friday 21st October 2005
quotequote all
Best price I have seen on the Silverstone is at

www.soundmasterscotland.com/productListing.aspx?id_manufacturer=45

To fit, if not already there, you will need the Porsche bracket. About £35 from OPC. Wiring is already in the car which has been stated earlier in the thread.

Mine was fitted with heavyweight double sided tape as the Silverstone has different fixing holes to the bracket. It looks just fine.

Don't forget to set the angle of the player (big round disc on side of player) as it will be upright and the unit comes out of the box with the angle set at horizontal.

The CDC-3 also turn up on ebay evry now and again. I think there's one on at the moment. Personally I went the new route with the Silverstone and live with the fact it doesn't have Porsche written on it.

magriggs

Original Poster:

875 posts

249 months

Friday 21st October 2005
quotequote all
There's a Silverstone 7860 on eBay at the moment.

Stirlings

324 posts

250 months

Tuesday 25th October 2005
quotequote all
Be carefull
There are 2 types of becker silverstone i forget the nos but you can buy one type new for less than £200, BUT ITS NOT the same as the Porsche changer,
The porsche CDC3 is about £450 from porsche , BUT is only £200 exchange, so its cheaper to buy a knackered one off ebay for £50 then part exchange it for a new one from porsche
The difference in the becker Silverstone models is the size,
the Becker importers are sempal www.sempal.co.uk

BliarOut

72,863 posts

266 months

Tuesday 25th October 2005
quotequote all
C2 or C4? The FWD bits get in the way of the standard changer on the C4.

Stirlings

324 posts

250 months

Tuesday 25th October 2005
quotequote all
the mounting brackets are different
but the changer is the same
But note that 03 cars with "most "technology use a CDC4 which must be programmed to the car by an OPC


www.stirlings.co.uk
the low mileage porsche specialists

BliarOut

72,863 posts

266 months

Tuesday 25th October 2005
quotequote all
Put a changer in a C4 and that's the boot gone.... Totally