2.8i manifold gaskets 1981/82

[david.h]

Anyone know the Ford (or Payen or Motorcraft) part nos for the head to manifold gasket? It is a "normal" oval type with two stud holes. There are two per side, and then there is a manifold to exhaust one whiich looks similar, but almost certainly isn't! Mine is blowing lke a good 'un at the rear o/s head/manifold joint, and when I change it I will no doubt disturb all the other ones, so may as well change the lot and skin all my knuckles at once!!

[kevsmev]

I was told by my local Ford dealer that they don`t do them anymore but you can get them thru most motorfactors. I recently replaced all four if mine when the engine was out. If I get chance tinite I will try to did out the part number. The join between the manifold and downpipe dosen`t have a gasket, just some sealer on the faces of the clamped ring.
Kev

[kevsmev]

Payen part# JC365 pack of 4
Kev

[david.h]

Thanks to you both

[david.h]

Thanks to you both