TVR Chim 500 2000 reg not start suggestions please
TVR Chim 500 2000 reg not start suggestions please
Author
Discussion

Drummerboy

Original Poster:

4 posts

248 months

Monday 2nd January 2006
quotequote all
Can anyone help?

I can get into my car, have checked battery, dash lights etc good, led lights etc say ready to start, fuel pump I can hear I turn the key and absolutely nothing. I took the car for a drive parked it and then nothing at all

grahamw48

9,944 posts

267 months

Monday 2nd January 2006
quotequote all
Check your earth connections first, especially the strap from battery
to engine or gearbox.

David H

809 posts

270 months

Monday 2nd January 2006
quotequote all
Check the connections on the starter, including the small spade connector on there.

Guillotine

5,516 posts

293 months

Monday 2nd January 2006
quotequote all
starter solenoid cooked...hit it.

Drummerboy

Original Poster:

4 posts

248 months

Monday 2nd January 2006
quotequote all
Thank you everybody I will work through points and get back to you tomorrow

seasider

12,728 posts

278 months

Monday 2nd January 2006
quotequote all
My bet is a low/fd battery...

Drummerboy

Original Poster:

4 posts

248 months

Monday 2nd January 2006
quotequote all
No it is not the battery as have removed this and put new fully charged battery in it's place same problem. All interior lights work, headlights strong etc. so sure not battery.

seasider

12,728 posts

278 months

Monday 2nd January 2006
quotequote all
Drummerboy said:
No it is not the battery as have removed this and put new fully charged battery in it's place same problem. All interior lights work, headlights strong etc. so sure not battery.
I lost that one then !!!

Duke Thrust

1,680 posts

268 months

Tuesday 3rd January 2006
quotequote all
Immobiliser problem?

wildeep

362 posts

278 months

Tuesday 3rd January 2006
quotequote all
Sounds like an immobiliser problem. I and many others have had the same problem with the factory fit Meta unit. Easiest way to check is to see if you have 12v at the starter solenoid wire when cranking. You can check this either at the starter itself using a voltmeter or in the passenger footwell as the starter wiring goes through there too. You may be able to short the solenoid to crank it over using a screwdriver between the terminals on the starter. Just make sure its not in gear!.

Sharky500

413 posts

258 months

Tuesday 3rd January 2006
quotequote all
Could be the Hot start problem? You didnt say if you tried to start it immediately after your drive. Try leaving her 10-15 mins, then try. If it starts, I think it's the dreaded hot start problem.

If so, do a search, there are loads of posts about it. There is also a kit from Mod-Wise that fixes it.

Drummerboy

Original Poster:

4 posts

248 months

Tuesday 3rd January 2006
quotequote all
Thanks everbody, I got a mallet wacked the starter motor (gently) and she started. Thank you everybody for all your help and advice