Coloured Glass DIY
Discussion
We were in John Lewis's at the weekend and noticed they are selling coloured glass Kitchen Worktops and Splash backs. The worktops looked like they would scratch easily and indeed already showed signs of damage, but the splash backs looked ideal for going behind the Rayburn we have just installed.
The prices quoted were astounding and worked out at about £1200 for a small section when Jigged!!!
Question is:- if I were to get a piece of toughened glass polished edges and drilled for wall mounting, would it look as good if I sprayed Acrylic paint on the back (two or three coats) and then hung it up?
Am I missing something blatantly obvious?
Cheers
Nick
The prices quoted were astounding and worked out at about £1200 for a small section when Jigged!!!
Question is:- if I were to get a piece of toughened glass polished edges and drilled for wall mounting, would it look as good if I sprayed Acrylic paint on the back (two or three coats) and then hung it up?
Am I missing something blatantly obvious?
Cheers
Nick
Aprisa said:
Question is:- if I were to get a piece of toughened glass polished edges and drilled for wall mounting, would it look as good if I sprayed Acrylic paint on the back (two or three coats) and then hung it up?
No need to spray as you can get coloured manifestation/film and apply it to the back of the glass before mounting.
ETA best effect is to paint the wall white and it needs to be plastered to a good level i.e. be absolutely smooth and flat so lots of rubbing down needed.
>> Edited by sleep envy on Monday 13th March 12:51
Looks good as splashbacks/upstands but you need spot-lights to give it a good effect. (i.e. undercupboard low-voltage)
It is a lot of hassle to size up and fit (all plug sockets and edges need cutting out before colouring and toughening the glass) if it comes back even mm out you're shafted. (Firms that supply and fit use hardboard to make up the templates).
Its adhered to the wall using a silicon type compound, but you have to be careful about which one to use, cause if the colouring hasnt been done properly on the glass, it shows through and looks pants! (especially when the spots shine on it).
Also, if you have any movement 'at all' from the wall (i.e. new plaster, heating pipes running behind) forget it, because the glass cannot take it and you'll end up with it either a) falling off the wall/coming loose or b) splitting.
It does look stunning in the right places & installed properly, but dont try and scrimp, you will regret it in the long run.
It is a lot of hassle to size up and fit (all plug sockets and edges need cutting out before colouring and toughening the glass) if it comes back even mm out you're shafted. (Firms that supply and fit use hardboard to make up the templates).
Its adhered to the wall using a silicon type compound, but you have to be careful about which one to use, cause if the colouring hasnt been done properly on the glass, it shows through and looks pants! (especially when the spots shine on it).
Also, if you have any movement 'at all' from the wall (i.e. new plaster, heating pipes running behind) forget it, because the glass cannot take it and you'll end up with it either a) falling off the wall/coming loose or b) splitting.
It does look stunning in the right places & installed properly, but dont try and scrimp, you will regret it in the long run.
Gassing Station | The Pie & Piston Archive | Top of Page | What's New | My Stuff



