indicator bleeper
Discussion
Hi guys! For those of you who have an early cerb with no indicator bleeper!
On the circuit board behind the clocks theres a bit that says buzzer but no adjuster!
Heres a quick remedy! Dont remove the top of the dash cos connecting a buzzer to the terminals marked does nothing, and i didnt hav a circuit diagram or the patience!
So go to the car spares shop and buy an indicator signal relay(for the tow bars) about a fiver! Then open it up and pull out the signal bleeper bit with two wires on it, then go in the boot and pull out the flasher relay!
Then get the bleeper, and put one wire in the left terminal of the fuse box and the other wire to the top terminal(where the flasher relay fits)
Then gently put back the relay whilst the wires are wedged in place!
All done! shut the boot sit inside and it works on hazards and indicators!
15 mins job and no more leaving them on without knowing
On the circuit board behind the clocks theres a bit that says buzzer but no adjuster!
Heres a quick remedy! Dont remove the top of the dash cos connecting a buzzer to the terminals marked does nothing, and i didnt hav a circuit diagram or the patience!
So go to the car spares shop and buy an indicator signal relay(for the tow bars) about a fiver! Then open it up and pull out the signal bleeper bit with two wires on it, then go in the boot and pull out the flasher relay!
Then get the bleeper, and put one wire in the left terminal of the fuse box and the other wire to the top terminal(where the flasher relay fits)
Then gently put back the relay whilst the wires are wedged in place!
All done! shut the boot sit inside and it works on hazards and indicators!
15 mins job and no more leaving them on without knowing
Gassing Station | Cerbera | Top of Page | What's New | My Stuff