Speed Bumps Advice
Discussion
As a potential GT3 newbie and living in a speed bumped city - can someone advise me please how best to approach/drive through speed bumps or tricky underground car parks ?
Hate to be replacing spoilers each week and what is the cost if that happens roughly?
Thanks in advance to all on this great site.
Hate to be replacing spoilers each week and what is the cost if that happens roughly?
Thanks in advance to all on this great site.
Edited by 343bhp on Tuesday 18th July 16:22
I bought my Mk.1 GT3 in January. Crunched the black plastic lip below the front apron the day I bought it. A new one cost me in the region of £38.
I haven't bothered to fit it as it seems that damaging this item is all part of owning such a superb piece of motor.
I studiously avoid any roads I where I know there are speed humps.
I have successfully negotiated a few by approaching same at an acute angle, but obviously this action depends very much on traffic conditions at the time.
>> Edited by runner911 on Sunday 28th May 08:40
I haven't bothered to fit it as it seems that damaging this item is all part of owning such a superb piece of motor.
I studiously avoid any roads I where I know there are speed humps.
I have successfully negotiated a few by approaching same at an acute angle, but obviously this action depends very much on traffic conditions at the time.
>> Edited by runner911 on Sunday 28th May 08:40
I've got a lowered C2 with the GT3 kit on it. The black lip catches all the time, even getting the car in and out of the garage.
There's some local roads I can't use because of the speed bumps, and I generally avoid multi-storey car parks.
I've already got a replacement lip which I'll put on when I sell, so I don't worry about it.
Someone else on here said they took theirs off with no adverse effects.
There's some local roads I can't use because of the speed bumps, and I generally avoid multi-storey car parks.
I've already got a replacement lip which I'll put on when I sell, so I don't worry about it.
Someone else on here said they took theirs off with no adverse effects.
I am afraid that on a car like this, the lower lip spoiler is a consumable item !
Even on my 996TT, thats not quite as low, I have replaced it twice in 2 years.
Only yesterday I drove into a garage for petrol & there was a dip on the entrance that grounded it. And multi-story carparks, going up & down the ramps can be a killer. Speed bumps actually are not as problem in the TT, but would be in the GT3 I imagine.
As mentioned, very slow & at an acute angle as possible.
I think Porsche probably know this, which is why its an easy item to remove and quite a cheap part & not part of the bumper itself which would cost a fortune to replace.
R.
Even on my 996TT, thats not quite as low, I have replaced it twice in 2 years.
Only yesterday I drove into a garage for petrol & there was a dip on the entrance that grounded it. And multi-story carparks, going up & down the ramps can be a killer. Speed bumps actually are not as problem in the TT, but would be in the GT3 I imagine.
As mentioned, very slow & at an acute angle as possible.
I think Porsche probably know this, which is why its an easy item to remove and quite a cheap part & not part of the bumper itself which would cost a fortune to replace.
R.
I drive a GT3 into central London most days. Like many owners I knocked off the lip spoiler within a few weeks of getting the car.
It's held on by nylon bolts so as to not damage anything else when it detaches.
I found it does make a significant difference to high speed stability and I wouldn't want the bottom of the front bumper exposed...so I replaced it (cost about £120 if I recall)
Also had JZM set the ride height to upper end of factory specification and haven't had any groundings for a few months now.
The trick is to approach any obstacles at an angle...you'll soon get the hang of it.
It's held on by nylon bolts so as to not damage anything else when it detaches.
I found it does make a significant difference to high speed stability and I wouldn't want the bottom of the front bumper exposed...so I replaced it (cost about £120 if I recall)
Also had JZM set the ride height to upper end of factory specification and haven't had any groundings for a few months now.
The trick is to approach any obstacles at an angle...you'll soon get the hang of it.
there seems to be a big discrepancy in the price of this lower lip. Mine has always been missing on my aerokit and at 40 quid it seems rude not to replace it... At 120 sovs it seems a bit expensive for a 'consumeable' item.
Where is the best place to purchase said item at that nice lower price please.
Where is the best place to purchase said item at that nice lower price please.
this is the only downside of gt3 ownership! not sure if the mk2 / rs is any better. I would keep the plastic lip on - you can often hear it grounding and is a good early warning signal that you're about an inch away of damaging something more expensive. Only solution is Ruf hydrolic dampers, about £10,000 a throw...
I've found you can actually get over some pretty extreme obsticals, but you very low speed and a very narrow angle of approach, which is not always possible.
I've found you can actually get over some pretty extreme obsticals, but you very low speed and a very narrow angle of approach, which is not always possible.
The bottom line is that you have to go over speed bumps very slowly indeed. 'The noise' typically occurs as you roll off of the bump and the lip grounds under compression of the suspension. I am fairly careful with it and despite a fair few groundings I have not yet (touch wood) knocked it off. Personally, I think that the greater problem with speed bumps on the GT3 is that you feel your suspensions pain if you hit them at anything above walking pace (regardless of whether they are high enough to bring the lip into play) due to the firm ride. But I can live with that.
As for those removing the lip - frankly I wouldn't entertain it. Pootling around town it would be fine, but as you reach those 'track only' speeds (officer) you do become aware of the front end lift (the wing wholey negates lift at the back, but it is only reduced at the front). At high speed I think that reducing front aero without doing the same at the rear could be really dangerous. If anything I would want more front aero - if it weren't for the bloody speed bumps...

As for those removing the lip - frankly I wouldn't entertain it. Pootling around town it would be fine, but as you reach those 'track only' speeds (officer) you do become aware of the front end lift (the wing wholey negates lift at the back, but it is only reduced at the front). At high speed I think that reducing front aero without doing the same at the rear could be really dangerous. If anything I would want more front aero - if it weren't for the bloody speed bumps...

Mine came off at Bedford once, and to be honest I didn't feel it (c. 150 indicated on the back straight so going fast enough).
Brake ducts on the GT3 mk2/RS take a fair battering too.
Mine are all damaged, but I just put them back on, or tape them up until they are no longer serviceable. No point being precious about them as they are simply incompatible with English roads and councils obsessed with speed bumps + pillows everywhere. Found I get hooted a bit going slowly+diagonally over bumps - especially out of London.
DanH said:
Brake ducts on the GT3 mk2/RS take a fair battering too.
Less than 2000 miles and they're totally trashed. The N/S one is so badly damaged all the retaining lugs are shot, it only has to get a sniff of a bump in the road and it reverts to "roadsweeper" mode.
I seem to recall Tech 9 did some big ducts that bolted onto the hub carrier and chanelled the air directly onto the rear face of the disc. Does anyone know where the cold air was ducted from ?
slippydiff said:
DanH said:
Brake ducts on the GT3 mk2/RS take a fair battering too.
Less than 2000 miles and they're totally trashed. The N/S one is so badly damaged all the retaining lugs are shot, it only has to get a sniff of a bump in the road and it reverts to "roadsweeper" mode.
I seem to recall Tech 9 did some big ducts that bolted onto the hub carrier and chanelled the air directly onto the rear face of the disc. Does anyone know where the cold air was ducted from ?
Have you tried gaffer tape?

I don't find speed humps too much of a problem in my MK1. Just don't approach one square on ie turn the wheel to the left or right so the wheel hits the hump first and lifts the front of a car in the air.
Ramps especially in car parks are a killer though. I would avoid multy storey car parks at all costs.
I don't think the splitter has any effect at normal road speeds so proberbly ok to take it off. Someone told me that you tend to suffer more understeer on track when cornering at high speed but never been on track minus the splitter so don't know whether this is try or not.
Ramps especially in car parks are a killer though. I would avoid multy storey car parks at all costs.
I don't think the splitter has any effect at normal road speeds so proberbly ok to take it off. Someone told me that you tend to suffer more understeer on track when cornering at high speed but never been on track minus the splitter so don't know whether this is try or not.
Yes, I had to have the entire front end of my GT3 rebuit after it was written off on a speed bump, twice, and then 3 new engines, and I only managed to get a tired 2001 C2 engine, though it polished up nice and looked genuine.
This is of course an utter lie, but I want to worry the new owner so he will give it me back....I miss my car

This is of course an utter lie, but I want to worry the new owner so he will give it me back....I miss my car

Gassing Station | Porsche General | Top of Page | What's New | My Stuff




