Resetting chip?

[Seany88]

Just wondering about what is required or if its even possible to reset the servicing chip i.e. when i've done the oil service myself.

[raceboy]

Not knowing the car I'm not sure, but...........

Euro Car Parts might be worth a look.
In theory it can be done with a piece of wire inserted across the right two ports in the plug, but the propper tool is a little safer.

Arrr just spotted the thread below, your cars probably a little too new for that reset tool, but I'm sure there'll be one on the market somewhere.

Edited by raceboy on Thursday 29th June 16:59

[andysv]

remap guys should be able to do this or try the exchange and mart.

[thesilverfox]

If it`s got the round plug under the bonnet just earth No 7 pin and it reverts to inspection.If thers no plug it`s done on the dash

[Seany88]

Right, done some digging on the net and found out that E46's don't have a diagnostic connector on the engine bay.

From here: [url]www.bimmerdiy.com/e46[/url]

"You should not have the 20-pin DLC connector. You only need to hold the left odometer reset button while turning the key to position 1 (Accessory). Keep holding the button for 5 or so seconds until any of the following shows in the display: OIL SERVICE or INSPECTION with RESET or RE. Release the button and press it again for another 5 or so seconds until RESET or RE flash. While the display flashes, press the button one more time briefly. If done correctly, END SIA should show up for a few seconds. All done. "

HTH others, just got to find out prices for oil filter and oil tomorrow. What oil is recommended for the 320d? I think i'll stick with what bmw recommends.