just found out my 'liz suffers from red hose syndrome :(
Discussion
A couple of weeks ago I was on a long trip .The weather was extremely hot. gave a friend of mine a ride
in the car and all of a sudden I couldn't engage any gears.
We got stuck in the middle of the road until I eventually managed to force it into 1st.
A couple of hours later I drove home and the problem was gone. Didn't experience it until today when I got home after a long trip and suddenly it wouldn't go into any gears again
It's also very hot outside today.
So I did a little bit of reading on the net
and I discovered this so-called 'red hose syndrome' .
I ran outside to check if I had it in my car..And yes
There it is. Bloody red hose
Lotus engineers really messed this one up
How on earth could they even consider strapping a ruber hose to the coolant pipes and not expect it to f*ck up
Ordering a stainless steel clutch hose from eliseparts right now.
Have anyone here had it done to their car ? How much work is required ? I have no idea how to get those sill panels off . Might have to give in and let a lotus dealership to it
in the car and all of a sudden I couldn't engage any gears.
We got stuck in the middle of the road until I eventually managed to force it into 1st.
A couple of hours later I drove home and the problem was gone. Didn't experience it until today when I got home after a long trip and suddenly it wouldn't go into any gears again
It's also very hot outside today. So I did a little bit of reading on the net
and I discovered this so-called 'red hose syndrome' . I ran outside to check if I had it in my car..And yes
There it is. Bloody red hose
Lotus engineers really messed this one up
How on earth could they even consider strapping a ruber hose to the coolant pipes and not expect it to f*ck up
Ordering a stainless steel clutch hose from eliseparts right now.
Have anyone here had it done to their car ? How much work is required ? I have no idea how to get those sill panels off . Might have to give in and let a lotus dealership to it

had this problem last year and asked lotus dealer how much it would be, £70 for a cable £400 to fit apparently as they had to take the clam off.. hmm bit dodgey that as the eliseparts one seems to suggest its quite easy.
Not had the prob until i went to Europe a couple of weeks ago, smack in the centre of Geneva in traffic, no first gear... left it to cool for 30 mins and all ok again. Apparently not a "design fault" i would beg to differ!
heat volatile pile rung directly alongside something hot! nope, no prob with that...
Not had the prob until i went to Europe a couple of weeks ago, smack in the centre of Geneva in traffic, no first gear... left it to cool for 30 mins and all ok again. Apparently not a "design fault" i would beg to differ!
heat volatile pile rung directly alongside something hot! nope, no prob with that...
May well be worth searching sites for help as you can quite easily ( with patience ) fit the hose yourself, apparently. The trick I always use on cables is to leave the original in place and feed the new one along it. If you run into areas where this is impossible. just feed the old cable through gaps with the new one tied to it.
Patience is the key. Allow yourself a weekend to do it.
Even if you then have some trouble bleeding the system, a dealer should not ask more than £20 to do this. Bit better than £400!
( You may as well buy a DIY powerbleeder kit, or just bleed with patience )
Patience is the key. Allow yourself a weekend to do it.
Even if you then have some trouble bleeding the system, a dealer should not ask more than £20 to do this. Bit better than £400!
( You may as well buy a DIY powerbleeder kit, or just bleed with patience )
yeah i thought that all you should have to do is attach the old to new and feed through, unless there is some tight spots along the way. Spoke to the service reception guy and not the mechanic to be fair but he said the clam had to be removed etc, probably the easiest way to do it, and most profitable for them but prob not the only way to do it.
thanks for all the suggestions. I had a look in the service manual and they suggest to remove the left hand side dash panel and the left hand sill coin tray. That should be enough
Then use the old pipe to pull the new pipe through.
I thought they'd fastened the pipe to the coolant return line, but apparently not
I thought the sill had to come off. If I can do it without removing the sill I'll give it a try. If it's 400GBP at a dealership
I'll gladly use a couple of days if that's what it takes
Then use the old pipe to pull the new pipe through. I thought they'd fastened the pipe to the coolant return line, but apparently not
I thought the sill had to come off. If I can do it without removing the sill I'll give it a try. If it's 400GBP at a dealership
I'll gladly use a couple of days if that's what it takes
are they a main dealer?
Just booked s1 elise in for a £90 radiator fan change and advised total bill will be £517!
How can lotus get away with making stuff so hard to get to that they can then profit from the overpriced repair bills!
only broke cuz they installed them in a stupid place so water drips onto them, the same as the clutch cable.. amazing how we accept such poor design really, good job it drives so well!
Just booked s1 elise in for a £90 radiator fan change and advised total bill will be £517!
How can lotus get away with making stuff so hard to get to that they can then profit from the overpriced repair bills!
only broke cuz they installed them in a stupid place so water drips onto them, the same as the clutch cable.. amazing how we accept such poor design really, good job it drives so well!
Exactly the same thing happened to my S1 about a year ago. Misery!
Managed to fit the braided hose off eliseparts myself. It's a bit fiddely but defo worth having a go to save £400! From what I remember you just need to remove the front left part of the dash, and rear floor pannel. There are a couple of cable ties securing the red hose at the front near the dash, and a couple at the back which you can reach from the floor pannel you've removed. Hose runs down the inside of the left sill.
Then it's just a case of strapping the new hose to the old one and dragging it through!
Best of luck!
Managed to fit the braided hose off eliseparts myself. It's a bit fiddely but defo worth having a go to save £400! From what I remember you just need to remove the front left part of the dash, and rear floor pannel. There are a couple of cable ties securing the red hose at the front near the dash, and a couple at the back which you can reach from the floor pannel you've removed. Hose runs down the inside of the left sill.
Then it's just a case of strapping the new hose to the old one and dragging it through!
Best of luck!
Hi Guy's,
I seem to remember that this problem is/was subject to a recall and Lotus were fixing it under warrenty. I think it applied to early S1's. I had a R plate car and as far as I remember the dealer sorted it before it became an issue.
Worth checking the assorted recall's for the S1 before spending your own cash :-)
I seem to remember that this problem is/was subject to a recall and Lotus were fixing it under warrenty. I think it applied to early S1's. I had a R plate car and as far as I remember the dealer sorted it before it became an issue.
Worth checking the assorted recall's for the S1 before spending your own cash :-)
s7oneyuk said:
does anyone know if this is limited to a specific variant - or does it affect all liz's (S1 / S2 / exige etc)?
S1 Elises only, cars up to early '99 iirc. You can find out recalls for your particular car here www.grouplotus.com/generic/generic.php?section=9&page=12&page_id=35
Hmmm. So mine's a '98 and shows no recalls outstanding.
I have a red hose. Can't believe someone has had the red hose replaced on warranty and then gone and put another red hose back on.
Can't be a recall item. Should be, though. It's clearly a design fault.
After the last two day's red hose nightmare on the M6, I feel a call to Horizon is on the cards.
I have a red hose. Can't believe someone has had the red hose replaced on warranty and then gone and put another red hose back on.
Can't be a recall item. Should be, though. It's clearly a design fault.
After the last two day's red hose nightmare on the M6, I feel a call to Horizon is on the cards.
just received mine yesterday and my mechanic was going to fit it but didnt realises it was such a job, even on the instructions from eliseparts they state it is a bit of a pain to fit. the mechanic called elise parts and they agreed it would take 2 mechanics about 4 hours labour! thats £180 i could do without spending!
97 elise and mine shows no recalls, even with a red hose.
Also, if the hose is the same and routed the same way, why would only early models be recalled when they suffer from the same prob?
Also, if the hose is the same and routed the same way, why would only early models be recalled when they suffer from the same prob?
david@mediacopy said:
Hi Guy's,
I seem to remember that this problem is/was subject to a recall and Lotus were fixing it under warrenty. I think it applied to early S1's. I had a R plate car and as far as I remember the dealer sorted it before it became an issue.
Worth checking the assorted recall's for the S1 before spending your own cash :-)
I seem to remember that this problem is/was subject to a recall and Lotus were fixing it under warrenty. I think it applied to early S1's. I had a R plate car and as far as I remember the dealer sorted it before it became an issue.
Worth checking the assorted recall's for the S1 before spending your own cash :-)
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



