bradied clutch hose installation instructions
Discussion
Hi,
After the post on the red clutch hose i noticed a braided one on ebay and purchased it. I dont know if it comes with instructions so would be pleased if someone who has the instructions or recently purchased one of these could scan the instructions and email me at, choo3@lineone.net
Thanks
Matt
After the post on the red clutch hose i noticed a braided one on ebay and purchased it. I dont know if it comes with instructions so would be pleased if someone who has the instructions or recently purchased one of these could scan the instructions and email me at, choo3@lineone.net
Thanks
Matt
Really easy, just done mine. Remove the plastic trims either side of the radio(pinch them top and bottom and they pull out). Undo the screws that are then exposed holding the dash top roll in place. Remove the steering column shroud. Pull the dash top roll backward from the dash and it then comes off, exposing the electrics behind the dash. Remove the coin tray from the lh sill (Held in by mastic, slide a long blade underneath and cut away carefully).
Remove the rear undertrays. You will see the clutch hose (encased in foam)disapearing into the LH rear of the sill panel. Feel along it and you will locate 3 tie wraps holding the clutch pipe to the cooling pipe, cut these. Disconnect the clutch pipe at the slave cylinder, and tie the front of the new hose to the back of the old hose. Disconnect the clutch hose at the master cylinder and by pulling/pushing where the pipe enters the sill/at the front end of the sill by the dash and under the front bonnet you can pull the old hose out/new hose through. Reconnect everything, reassemble everything and your done. Only dark cloud is if the hose is the one i saw on ebay it has a curved metal section on each end, this will make it difficult to thread through (replacement ones are often straight ended with angled adaptors at each end). Worth the pain and lacerated forearms though, and the car is far more driveable in hot weather. Good luck.
Remove the rear undertrays. You will see the clutch hose (encased in foam)disapearing into the LH rear of the sill panel. Feel along it and you will locate 3 tie wraps holding the clutch pipe to the cooling pipe, cut these. Disconnect the clutch pipe at the slave cylinder, and tie the front of the new hose to the back of the old hose. Disconnect the clutch hose at the master cylinder and by pulling/pushing where the pipe enters the sill/at the front end of the sill by the dash and under the front bonnet you can pull the old hose out/new hose through. Reconnect everything, reassemble everything and your done. Only dark cloud is if the hose is the one i saw on ebay it has a curved metal section on each end, this will make it difficult to thread through (replacement ones are often straight ended with angled adaptors at each end). Worth the pain and lacerated forearms though, and the car is far more driveable in hot weather. Good luck.
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



