Do you need to 'scrub in' new tyres?
Discussion
Mornin' all,
I have 4 x new tyres (OEM RE040's) and have noticed the handling change a huge amount. It's like I can feel the movement of the blocks in the tyre (where they are now taller) and it just doesn't feel quite as direct.
Went for a blast the other night and it didn't fill me with as much confidence as usual. Do tyres need a few miles and a bit of wearing down just to scrub in so to speak?
Certainly my old ones (same tyre make) in the dry were great but alas Mr Plod would not have thought so!
Cheers all
I have 4 x new tyres (OEM RE040's) and have noticed the handling change a huge amount. It's like I can feel the movement of the blocks in the tyre (where they are now taller) and it just doesn't feel quite as direct.
Went for a blast the other night and it didn't fill me with as much confidence as usual. Do tyres need a few miles and a bit of wearing down just to scrub in so to speak?
Certainly my old ones (same tyre make) in the dry were great but alas Mr Plod would not have thought so!
Cheers all
It takes about 150-250 miles to clear off the release agent that's on the tyres to get them mould, more if you are driving gently and depending on the tyres going through a heat cycle or two will help with the grip they provide.
However if the last set of tyres were down to the wear bars and the new have deep tread on them you will have more squirm as the blocks move about. A long time ago when I raced in caterhams and they have a van tyre as a control tyre there was almost 2 secs a lap and brands indy just by getting the tyre buffed back from new to about 3mm....
However if the last set of tyres were down to the wear bars and the new have deep tread on them you will have more squirm as the blocks move about. A long time ago when I raced in caterhams and they have a van tyre as a control tyre there was almost 2 secs a lap and brands indy just by getting the tyre buffed back from new to about 3mm....
ah excellent ok thanks it's the fronts which feel odd at the moment (they were put on a couple of weeks after the rears) so I'll just give them time to bed in.
As you say - the blocks are now higher and so moving around a bit (I don't know whether I'm making it up but it really is notiecable to the handling!).
Anyway thanks guys - that's put my mind at rest!
As you say - the blocks are now higher and so moving around a bit (I don't know whether I'm making it up but it really is notiecable to the handling!).
Anyway thanks guys - that's put my mind at rest!
When I had my black bmw Z3 M coupe and needed new tires(michelin pilots sports) they forgot to deflate them, you know they first pump them up hard to fit better, then deflate them to the proper pressure! but they forgot that on the fronts
instead of 2.2 they had 3.0! after a day driving I wondered it was more loud(tire noise) over bumps, and specialy at high speeds it was tramlining! and unstabel because of that..I was wondering what it could be..so I checked the wheelnuts? was oke...out for a spin again..hm...scary almost not what I'm used to feel...then I checked tire pressure
so deflate them and it was perfect again
so the right pressure is very very importend for the grip and handling and good feel with the car...so I also would check it again myself! if I was you...just to be sure.
GTRene
instead of 2.2 they had 3.0! after a day driving I wondered it was more loud(tire noise) over bumps, and specialy at high speeds it was tramlining! and unstabel because of that..I was wondering what it could be..so I checked the wheelnuts? was oke...out for a spin again..hm...scary almost not what I'm used to feel...then I checked tire pressure
so deflate them and it was perfect again
so the right pressure is very very importend for the grip and handling and good feel with the car...so I also would check it again myself! if I was you...just to be sure. GTRene
Edited by GTRene on Tuesday 11th July 11:03
TonyHetherington said:
mr_c said:
have you checked the pressures tony?
Yeah, they're fine; 26psi front, 27.5psi rear (I have the DCK dot coded tyres)
I run my S1 tyres a fair bit lower than that, although i don't know what S2 pressures are supposed to be.
I'm sure mine are all 2psi below what Lotus say. Horizon Motorsport set my car up and that was their recommendation.
S Works said:
Find a nice big open carpark
Do they exist?! Any car park now has trolley stands or street lights or any other numerous "keep away from" type stuff!!!
Hey, we've just got a new toy actually. Being completely childish I bought one of those performance meters (it was £40 or something stupid) and it arrived today. You know the ones that measure 0-60, 1/4mile, lateral g etc. Well, guess what I'm going to be doing tonight
That should sort the tyres out.
TonyHetherington said:
S Works said:
Find a nice big open carpark
Do they exist?! Any car park now has trolley stands or street lights or any other numerous "keep away from" type stuff!!!
Hey, we've just got a new toy actually. Being completely childish I bought one of those performance meters (it was £40 or something stupid) and it arrived today. You know the ones that measure 0-60, 1/4mile, lateral g etc. Well, guess what I'm going to be doing tonight
That should sort the tyres out.
Whereabouts will you be undertaking said evaluations?
TonyHetherington said:
S Works said:
Find a nice big open carpark
Do they exist?! Any car park now has trolley stands or street lights or any other numerous "keep away from" type stuff!!!
Hey, we've just got a new toy actually. Being completely childish I bought one of those performance meters (it was £40 or something stupid) and it arrived today. You know the ones that measure 0-60, 1/4mile, lateral g etc. Well, guess what I'm going to be doing tonight
That should sort the tyres out.
Sadly very rare these days - try to find somewhere which accommodates coach parking

Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



