Oil Cooler Help.

[TVRleigh]

I can no longer find my notes on how my Oil cooler goes back together, also I took the termostat apart
I have done a diagram on how I think it should go back together, using Pics I took of ones install in 4xxSE's and SEAC's

The main question are the hoses the right way going to the cooler, and is the thermostat valve the right way round.

Thanks for any help anyone can give.

Also could be usefull for others once we know its correct. as I have searched everywere to find out the correct fitting.

[TVRleigh]

Sorry to bump this, but somone must have taken there's apart as I've saw quite a few at BBWF with braided oil cooler hoses.

[gsx600]

Yep I did, but can't remember how I put it all together. I seem to remember checking which hose the oil pumped from on engine turnover ( by key) so I knew that was my out put, then connect to remote houseing turn engine again and make sure it went through the filter and out the other end, then the oil cooler had an arrow marked in and out.

Lots of oil later it still seem to work and holds a good pressure after nearly 2 years

good luck