Discussion
After managing to lock myself out of the house I eventually got into the S1 and decided to go for a blast to relax, however in my anger I managed to wind the window down a bit too fast, and pop, it was out of the runner! I'm sure this has been posted a million times before, but after getting the inside panel off I can't see any way to get the glass back in the runner at the rear of the door whilst at the same time getting the scissor type joint plastic runner back in to it's channel?? Any help would be greatly appreciated, as I really hope it isn't a door-off dealer job after spending all that money on 4 lovely Yoko A038's
!!
P.S. To the red Elise around Theydon Bois yesterday - Nice driving with you!
!! P.S. To the red Elise around Theydon Bois yesterday - Nice driving with you!
Don't worry, it's a piece of cake, if a little fiddly. Depends whether the runner has come away from the window or from the scissor mechanism.
If the glass is still attached to the horizontal bar then you need to undo the three nuts and release the window from the bar, replace the bar and put the nuts back on again. (You'll need to take out the door handle to get access to the put the front nut back on again.
If the glass has come away from its three plastic clips then you'll possibly need new ones - cheap from any dealer.
Useful link here:
www.elise-faq.info/content/windows/rebond.php
I've done this 4 times on 3 S1's, so it's a fairly common thing!
If the glass is still attached to the horizontal bar then you need to undo the three nuts and release the window from the bar, replace the bar and put the nuts back on again. (You'll need to take out the door handle to get access to the put the front nut back on again.
If the glass has come away from its three plastic clips then you'll possibly need new ones - cheap from any dealer.
Useful link here:
www.elise-faq.info/content/windows/rebond.php
I've done this 4 times on 3 S1's, so it's a fairly common thing!
It really doesn't take that long to do (well, not the third or fourth time around anyway! You'll need to take the glass right off the runner and pull it out - you can fairly easily remove the rubber trim that runs along the top of the door by the glass to facilitate this. It's a little fiddly but hey, it's good to learn about how things work. Eh?
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


