Rolling Road in the north for OMEX setup

[Mackempete]

Can anyone recommend a rolling road in the north that has experience of both the OMEX ECU's and the RV8. By north I mean somewhere between nottingham and Newcastle.

Any idea how much it would cost, assuming the ECU had a basic map on it and just required fine tuning?

[chassis 33]

First port of call would be Trackcar Solutions in chesterfield, although there is another one around there that joo used to use before getting his own rollers.

Regards
Iain

[Mackempete]

Cheers Iain. I've been trying to ring Jules on the mobile number listed on his site, no answer at the minute. I'll keep trying.

[mongoose]

Hi Peter,i used Nobles in chesterfield to get my Omex 710 mapped and darren there did a great job.This was before Julian had his rolling road at Track Car Solutions though,and was the road he always used until he got his own.It cost about £240ish from memory,that was to map completely new maps from a base map where it would only tickover,and mapping for both fuel and ignition of course.If i were in the same position now,then i would go to joo,as he now has experience of the Omex,after mapping mine,and i know he would also do a top job

[mackempete]

I'll keep trying him tomorrow. Poor bloke must struggle to get any work done for the phone ringing. Everytime I tried ringing this afternoon he was engaged...