Speedo failure S1 111S
Discussion
Has anyone suffered speedo failure on their Elise ?
For a while it kept bouncing up and down when I went over a bump, now it has stopped working completely.
This is the second time it has happened, last time I took it to the dealer, who said something about electircal corrosion somewhere.
I'm kinda fed up with taking this to the dealers to get fixed
so I thought I might have a go myself, if someone could point me in the right direction.
Regards
Scrote.
For a while it kept bouncing up and down when I went over a bump, now it has stopped working completely.
This is the second time it has happened, last time I took it to the dealer, who said something about electircal corrosion somewhere.
I'm kinda fed up with taking this to the dealers to get fixed
so I thought I might have a go myself, if someone could point me in the right direction. Regards
Scrote.
Sullen_Scrota said:
Has anyone suffered speedo failure on their Elise ?
For a while it kept bouncing up and down when I went over a bump, now it has stopped working completely.
This is the second time it has happened, last time I took it to the dealer, who said something about electircal corrosion somewhere.
I'm kinda fed up with taking this to the dealers to get fixed
so I thought I might have a go myself, if someone could point me in the right direction.
Regards
Scrote.
For a while it kept bouncing up and down when I went over a bump, now it has stopped working completely.
This is the second time it has happened, last time I took it to the dealer, who said something about electircal corrosion somewhere.
I'm kinda fed up with taking this to the dealers to get fixed
so I thought I might have a go myself, if someone could point me in the right direction. Regards
Scrote.
You can check for corrosion or just a loose plug at the speedo end yourself quite easily. It takes about 10 minutes to remove and only requires a screw driver and small socket. However if the unit itself has given up then your out of luck since they are a sealed unit. It it is an original Stack made one, Lotus outsourced production after a while and you can tell because it has two rather than one socket on the back, then send or take it to Stack themselves, they are based near Oxford. Unfortunately it's not cheap, fixed price of around £300, but that's at least half of what Lotus would charge and they are only going to send it to them anyway. Other than that I'll defer to someone else for their expertise.
Ok, just finished fixing this.
The cable was broken where the connector plugs into the wheel speed sensor in the nsr wheel arch.
There was zero slack on the cable, which was bent tightly through 180 degrees.
I've now soldered in another 2 inches of cable and every thing is fine, silky smooth speedo and no bouncing or oscillating.
Ruxpin, you were spot on (although I have to admit I finished fixing it before I read your post).
Now for the horn and the cigarette lighter, which have also stopped working.
Thanks
Scrote.
The cable was broken where the connector plugs into the wheel speed sensor in the nsr wheel arch.
There was zero slack on the cable, which was bent tightly through 180 degrees.
I've now soldered in another 2 inches of cable and every thing is fine, silky smooth speedo and no bouncing or oscillating.
Ruxpin, you were spot on (although I have to admit I finished fixing it before I read your post).
Now for the horn and the cigarette lighter, which have also stopped working.
Thanks
Scrote.
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


