S1 Sport 160
Author
Discussion

Planman350i

Original Poster:

599 posts

284 months

Monday 21st August 2006
quotequote all
Hello, just sold a TVR with a fairly well tuned 4 litre and now intent on buying an elise for weekend use and occasional track day. I know they are not about straight line power, but I'm beginning to think that the standard S1 will not be enough, and I will quickly want a bit more BHP. The Sport 160 is attractive for this reason, but I don't want somemthing thats going to stall all the time in town and be too low to cope with my local roads. So how impractical are they really?

amcphillips

934 posts

248 months

Monday 21st August 2006
quotequote all
Well I've just picked one up and at first it did keep stalling in town. However I think this was mainly because I didn't warm it up properly. I now sit in the car for about 10 minutes holding the revs steady until it reaches at least 55C before I'll even move. Also when approaching roundabouts, traffic lights etc you need to slow down early enough and work your way down the gears as this seems to keep the engine happier!

Speed bumps are no probs if you go down the middle of the road as opposed to a wheel either side with the biggest part of the "bump" under the middle of the car!

It should be available for hire soon if you want to "try before you buy!"

S works

10,166 posts

281 months

Monday 21st August 2006
quotequote all
Look to get a car which has had an Emerald and Verniers fitted and the cams retimed if you want it to be spot on all the time.

Some are better than others (my old one was lumpy but never stalled at a standstill), I was lucky I guess.

piooly

1,176 posts

256 months

Monday 21st August 2006
quotequote all
They wont stall !! You soon adjust, just use very slightly more revs when pulling off. And they are just about high enough to cope with speed ramps and the like. If you put some veniers and re-time the engine, you don’t need to get a new ECU. I've done this to my sport 160 and it drives like a normal car. Just get one, you'll love it.

Paul RN

1,168 posts

245 months

Monday 21st August 2006
quotequote all
Shouldn't really be stalling by itself only user error on input (ie not enough gas when pulling away). Might be your Idle Air Control Valve (http://wiki.seloc.org/index.php/IACV) at fault if you getting that. Heres a good thread on SELOC about it too http://forums.seloc.org/viewthread.ph

Now a 160 being lumpy and like a kangeroo below 3,000rpm thats normal and thats what can make them pigs in town.... but its all worth it when you're not

Hollywood Wheels

3,689 posts

261 months

Monday 21st August 2006
quotequote all
Paul RN said:


Now a 160 being lumpy and like a kangeroo below 3,000rpm thats normal and thats what can make them pigs in town.... but its all worth it when you're not


hehe All part of the fun! I've got into a very bad habit when in stop/start traffic. I whack it into neutral and freewheel along, avoids all the embarrassing kangerooing.

DVA Power will supply and fit the Lotus 'Driveability Kit' for about a grand. Could be budgetted into the equation when viewing potential cars. I'd be lying if i said the low-speed driving wasn't a pain, but the rest of the 160 experience more than makes up for it....