Calliper paint. Anyone tried it?
Discussion
emenel said:
I would really like yellow callipers on my black Exige and I know you can buy paint for this but is it completely sh!t?
I bought some POR-15 high temperature enamel for the front and rear callipers on the Esprit. Has survived two years of abuse with no chipping or fading. The secret is also in the preparation. They have to be cleaned perfectly.
kylie said:
TIPPER said:
Funnily I've been thinking about this, but was thinking of doing mine in black (to go with the wheels) and highlighting the Lotus graphic.
Anyone ever hand painted them?
Anyone ever hand painted them?
Hand painted mine using POR-15 as above. Looks the dogs bits

Excuse my ignorance, but what is POR-15 and where can I get some? Thanks
As above, the key is prep. I've seen people who literally take the wheel off, paint the bits they can see, and put the wheel back on. It looks awful!
If however you go the whole hog, prepare it well, take the caliper off etc...it can look really good. Also, make sure you introduce cleaning your calipers into your car washing routine. Just a quick rub with a sponge while doing the wheels means brake dust will never accumulate. The pic here is my wheels/calipers after 15000 miles...

If however you go the whole hog, prepare it well, take the caliper off etc...it can look really good. Also, make sure you introduce cleaning your calipers into your car washing routine. Just a quick rub with a sponge while doing the wheels means brake dust will never accumulate. The pic here is my wheels/calipers after 15000 miles...

Thanks emenel
It was done by Bell and Collvill for me when I bought the car with a spray. I've actually asked them what product they used because it was that good (and they're going to get back to me), will post back here when I find out. Incidentally, yellow calipers on black exige I think will look superb!!!
Tipper; also get some wire wool/wire brush. You'll need alot more than brake cleaner and it will give a nicer surface for the paint to take to. Other than that, spot on, and it will look very good!!
I stress to both of you, though, to get washing your calipers into your wash routine. It doesn't take very long at all for them to look tarnished and dirty and it will waste your efforts. Litearlly 20 seconds of washing them each time you do your wheels (which for me is 1/week) and will keep them looking like that pic above (which as I say is 15000 hard miles old)
It was done by Bell and Collvill for me when I bought the car with a spray. I've actually asked them what product they used because it was that good (and they're going to get back to me), will post back here when I find out. Incidentally, yellow calipers on black exige I think will look superb!!!
Tipper; also get some wire wool/wire brush. You'll need alot more than brake cleaner and it will give a nicer surface for the paint to take to. Other than that, spot on, and it will look very good!!
I stress to both of you, though, to get washing your calipers into your wash routine. It doesn't take very long at all for them to look tarnished and dirty and it will waste your efforts. Litearlly 20 seconds of washing them each time you do your wheels (which for me is 1/week) and will keep them looking like that pic above (which as I say is 15000 hard miles old)
TIPPER said:
Have I missed anything?
Oh yes also - you'll see the "Lotus" writing on my calipers has been done. If you want the same thing get yourself a paint pen (for yellow or red calipers I would suggest in black). It only has Lotus written on the front ones, the back are just small blocks of metal.
You must clearly be mistaken Cuzza, perhaps it's a speck of dirt on the camera lense?
Reagrding the wet and dry bit - couple of things spring to mind (though I've not tried it)...firstly, there are raised bits either side of the LOTUS writing, so you'd get them too. Also, would water not then get under the paint and it would corrode?
With a paint pen, a steady hand, and with the calipers off the car it should be ok!
Reagrding the wet and dry bit - couple of things spring to mind (though I've not tried it)...firstly, there are raised bits either side of the LOTUS writing, so you'd get them too. Also, would water not then get under the paint and it would corrode?
With a paint pen, a steady hand, and with the calipers off the car it should be ok!
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


