anti-freeze
Author
Discussion

Leftie

Original Poster:

11,838 posts

266 months

Friday 15th September 2006
quotequote all


The ani freeze in my S1 is a sort oy yellowy colour. I have seen gren, blue, red, but never yellow.


Can I top up with ordinary, common or garden blue stuff or is it some special elixr brewed by gre legged trolls in the mountains of Norfolk at £400 a litre that I need, as usual????

jondude

2,441 posts

248 months

Friday 15th September 2006
quotequote all
S1s normally run Unipart Superplus anti-freeze, which is not expensive but a bit tricky to get hold of. ( Halfords do not stock it. ) MG Rover, Land Rover dealers stock it, or you can go to the Unipart website and they will tell you your local stockist - a petrol station for me!

Should be more yellowy green though - more the rolling eyes icon rolleyes than

You most certainly should not mix anti-freezes. If you have Superplus ( which is a dog basic, no frills anti-freeze, then keep to it, unless you flush and treble flush the system. Mixing can cause hot spots, apparently...not wise in an engine where cooling is paramount.

I reckon it is Superplus. You could always buy a litre to colour match first!

Leftie

Original Poster:

11,838 posts

266 months

Friday 15th September 2006
quotequote all
jondude said:
S1s normally run Unipart Superplus anti-freeze, which is not expensive but a bit tricky to get hold of. ( Halfords do not stock it. ) MG Rover, Land Rover dealers stock it, or you can go to the Unipart website and they will tell you your local stockist - a petrol station for me!

Should be more yellowy green though - more the rolling eyes icon rolleyes than

You most certainly should not mix anti-freezes. If you have Superplus ( which is a dog basic, no frills anti-freeze, then keep to it, unless you flush and treble flush the system. Mixing can cause hot spots, apparently...not wise in an engine where cooling is paramount.

I reckon it is Superplus. You could always buy a litre to colour match first!


Sounds more like Colouroll at B and Q.

Leftie

Original Poster:

11,838 posts

266 months

Friday 15th September 2006
quotequote all
jondude said:
S1s normally run Unipart Superplus anti-freeze, which is not expensive but a bit tricky to get hold of. ( Halfords do not stock it. ) MG Rover, Land Rover dealers stock it, or you can go to the Unipart website and they will tell you your local stockist - a petrol station for me!

Should be more yellowy green though - more the rolling eyes icon rolleyes than

You most certainly should not mix anti-freezes. If you have Superplus ( which is a dog basic, no frills anti-freeze, then keep to it, unless you flush and treble flush the system. Mixing can cause hot spots, apparently...not wise in an engine where cooling is paramount.

I reckon it is Superplus. You could always buy a litre to colour match first!


Found this:

The S1 yellow coolant is Unipart super plus 2, the S2 green coolant is Unipart super plus 4, both available at reasonable cost from any Rover dealer. The two coolants should not really be mixed. For small topping up you can use plain water, but if you live in a hard water area, distilled, de-ionised or filtered rain water should be used.

The MIN level on the expansion tank is actually the correct coolant level when the engine is cold (when the engine is warm the level will rise). Be very careful if you try to remove the cap when the engine is warm - it may splash you with hot coolant.

Opinion on the use of "Water Wetter" (eg from Redline Oils) is divided. It is designed to helps to ensure Head Gasket Failure does not happen because it evens out the temperature within the engine block by creating a slick surface and stops isolated heat spots building up and damaging the engine and components. However, some people have found that it reacts badly with the rubber in some after market replacement head gaskets (causing HGF).

Bob van Melzen

There was a faulty batch of pressure caps (you can tell by the hole not being in the middle of the cap). A faulty cap means that the temperature is allowed to get too high and is therefore a possible cause of head gasket failure.

It is also possible for air to get trapped in the pipe that runs on top of the exhaust manifold on older cars. Older cars have a pipe running above the exhaust manifold (this point being higher that the bleed nipple), so some people have added a bleed nipple at that point. Later cars have this pipe running below the exhaust manifold so it is not a problem.

Mike Knowles

The standard Elise radiator is apparently (according to Lotus) good for 200bhp without modification. It contains a fan on the underside which is switched by means of the temperature sensor in the pipework next to the engine in the back. It turns on at roughly 99-102°C, and turns back off at roughly 90-92°C. The coolant reading on the Stack dash flashes at anything over 100°C.

The standard radiator has plastic side panels, which as a result of the heat/cool cycle have a tendency to crack and leak. This is a clam off job to replace the rad, and there are 3rd party variants available with steel side-tanks.

A frequently occurring fault with the radiator system is the left hand side radiator return hose coming off the radiator. This is normally held in place with a jubilee clip, and some either leave the factory with the clip not especially tight, or they become loose over time. If your rad hose clip has never been checked, never failed, or you were unaware of this problem, it's a good idea to have it checked by a garage when next in for service.

Sometimes, the gauge on the Stack dash can start to fluctuate wildly. This can be caused by several things. The causes are mainly due to the way the Stack dash gets it's information about the coolant temperature. This is via a sender that is located at one of the highest points in the cooling system, hence the following can indicate what's wrong:

- Broken sensor or wire
- airlock in coolant system at the sensor
- loss of coolant

However the main point here is to stop driving immediately as the causes range from trivial to fundamental, and the latter can be very expensive and lead to warping of the alloy cylinder head if the car isn't stopped immediately and the engine turned off.

In terms of the broken sensor or wire, the sensor is a known failure item, and is available at any Lotus or Rover (or trusted 3rd party Rover) dealer.

In terms of the airlock in the coolant system, this requires the coolant system to be bled properly.

Loss of coolant can occur from various places, namely the front rad hose, from the rad pipes that go through the chassis sidemembers, and from an Inlet Manifold Gasket or Head Gasket Failure (this is the worst case scenario).

In all cases, the temperature reading is liable to jump about in the region of roughly 20°C in a second, thereby pointing to one of the above scenarios.

Some people have warned against the use of Redline Water Wetter and other such coolant additives, and also against the use of 3rd party coolant as they are a supposed cause or contributor to Head Gasket Failure.

jondude

2,441 posts

248 months

Saturday 16th September 2006
quotequote all
Ha!

Actually, must admit it is confusing now! Mine is yellowy green, almost luminous. Is that S1 stuff or S2????

I guess all you can do is buy one type, then flush and flush the system anyhow - then make sure you always use the same.

If you do flush the system well, you can always use one of the more fancy anti-freezes available. Some out there now are good for 5 years.