tuscan body parts needed
Discussion
Do you mean the tonneau cover behind the driver? If so what part, because TVR supplied the whole tonneau cover in one piece and teams then cut them into a minimum of three pieces, sometimes 4, for installation?
I have a variety of pieces, sufficent to do the whole thing, in various configurations. I also have an exhaust cover.
I have a variety of pieces, sufficent to do the whole thing, in various configurations. I also have an exhaust cover.
Ah, right. You might struggle, as many cars simply have a hole. I have one tonneau with the hole 'liner' attached, but it is very firmly glued in and last time I tried I could not dislodge it without damaging it.
As an alternative you could cut a neat oval hole and then cover the otherwise sharp edges with a rubber 'U' trim section to stop it chafing the harness. Somewhere like Car Builder Solutions is good for this stuff - much cheaper than racing specialists.
www.nfauto.co.uk/rubber_trim.htm
Et voila
As an alternative you could cut a neat oval hole and then cover the otherwise sharp edges with a rubber 'U' trim section to stop it chafing the harness. Somewhere like Car Builder Solutions is good for this stuff - much cheaper than racing specialists.
www.nfauto.co.uk/rubber_trim.htm
Et voila
not progressing that fast but i know how long it can take to find some parts for these cars
but with a baby due around christmas i know i am not going to get a lot done for a few mounths after the birth so hope to get the car ready to go off for paint before or just after the new arrival
many thanks
but with a baby due around christmas i know i am not going to get a lot done for a few mounths after the birth so hope to get the car ready to go off for paint before or just after the new arrival
many thanks
Gassing Station | General Motorsport | Top of Page | What's New | My Stuff