Excessive Tappet Noise
Excessive Tappet Noise
Author
Discussion

stampede

Original Poster:

266 posts

249 months

Tuesday 26th September 2006
quotequote all
Dear all,

On a couple of occasions now I have noticed excessive tappet noise when coming down to lesser rev numbers after a good thrashing.

This continues for a period of time (even at idle) before diminishing to the more normal VVC top end "clickety-clackety".

2 questions,

1. Should I be worried about it?

2. If "yes to 1", what can I do about it?

Thanks in advance for any knowledgeable replies.

S690

zebedee

4,596 posts

309 months

Tuesday 26th September 2006
quotequote all
check your oil level - make sure it is full - low oil = noisy tappets

Sam_68

9,939 posts

276 months

Tuesday 26th September 2006
quotequote all
Q1) Yes

If it is happening only after spirited driving, first suspect would be oil temperature.

The Elise K-series installation is known for high oil temperature, so if you are thrashing the car, chances are the oil may have heated up to the point where viscosity has reduced enough that the bleed-down from the hydraulic tappets is enough to allow the clearances to open up a little. If this is the case, then apart from the increased cam wear that the top end noise is warning you about directly, the oil will be giving less protection to other parts of the engine.

Q2) Consider:
1) Using better quality oil or more frequent oil changes
2) Fitting an oil cooler, if the car doesn't have one already (I can't remember whether they were standard fitment on the 111S).
3) Fitting oil temperature and/or pressure gauges, so you can see what is going on with the oil.
4) Driving slower.*








* Only kidding!

stampede

Original Poster:

266 posts

249 months

Tuesday 26th September 2006
quotequote all
zebedee said:
check your oil level - make sure it is full - low oil = noisy tappets


yikes SH*T!!!!!!!!!!!!!!!! Less than 3k from service and no oil left - that explains it then!

Now the question is, shout WHO'S KNICKED ALL MY OIL???????? shoot

Thanks z for getting me to check.

S690

stampede

Original Poster:

266 posts

249 months

Tuesday 26th September 2006
quotequote all
Seeing as I have to drive home this evening with a teaspoons worth of oil in the sump and I can't remember what oil is inside currently (synthetic, semi-synth, olive, sesame.........)

Any recommendations of what I should buy at the local Tescos forecourt?????????????

S690

beachbum

2,610 posts

262 months

Tuesday 26th September 2006
quotequote all
stampede said:
Seeing as I have to drive home this evening with a teaspoons worth of oil in the sump and I can't remember what oil is inside currently (synthetic, semi-synth, olive, sesame.........)

Any recommendations of what I should buy at the local Tescos forecourt?????????????

S690


Easiest answer, the best they do, cos their best isnt usually that great any way

stampede

Original Poster:

266 posts

249 months

Tuesday 26th September 2006
quotequote all
How do I know it's the best?

shangani

3,069 posts

268 months

Tuesday 26th September 2006
quotequote all
Off the Tescos forecourt, Mobil 1 your best bet, followed by castrol magnatex.

stampede

Original Poster:

266 posts

249 months

Tuesday 26th September 2006
quotequote all
shangani said:
Off the Tescos forecourt, Mobil 1 your best bet, followed by castrol magnatex.


Ta Shangers,

Does it matter if it's synthetic or not?

Dave.

zebra

4,555 posts

245 months

Tuesday 26th September 2006
quotequote all
You're not the only one with tappit noise _ if it persists when you've got your oil at the right level get it checked out and have the tappits seen to. Mine sounds like a sewing machine at the moment; appears to be a common problem on the toyota lump.

zebra

shangani

3,069 posts

268 months

Tuesday 26th September 2006
quotequote all
A high revving engine like the VVC (even more so for the yota) probably deserves a decent oil. I would get a semi-synthetic at least eg - magnatec. 4.5l is not too pricy - £20 from Halfrauds. That said, Tesco's own brand is apparently produced at the same plant as Castrol GTX Magnatec.

I track my car, so it runs at high rpm. Oil is the only thing keeping the engine lubricated, so it is rather important.

jondude

2,441 posts

248 months

Wednesday 27th September 2006
quotequote all
You also want to be sure you have the correct grade of oil.

One which is too thin will give more tappet noise, one which is too thick will reduce the noise - but take longer to warm up and so wear the engine faster. ( Filling your car with a heavy viscosity oil before selling it is a classic wide boy trick - it will sound so much sweeter )

Now I've started typing, I can't see what car you have - but the Elise tends to have a 5w-40 as the recommended oil. Tesco will probably stock 10w-40 as the main....this is thinner and may not 'cure' your tappet noise.

If you run the recommended oil, keep it topped up and still get the noise, it is time to think more seriously...

stampede

Original Poster:

266 posts

249 months

Wednesday 27th September 2006
quotequote all
Thanks to all.

1.5l of Magnatec now installed and the P&J is now as quiet as a sleeping baby.

Does anyone have a feel as to how much oil consumption a mildly tuned VVC should have in normal road driving conditions as 1.5l in ~4k miles seems a little high to me.

S690

Sam_68

9,939 posts

276 months

Wednesday 27th September 2006
quotequote all
That's a little on the high side for a tuned K-series, but not beyond the realms of possibility.

Are you sure it was topped up correctly at the last service? Forgive me if I am jumping to unfair conclusions, but if you are the sort of person who doesn't regularly check your oil (teacher it's supposed to be a weekly maintenance check!), then did you actually check it when it cam back from its lasts service? I've known plenty of garages fail to add enough oil at services to even reach the bottom marker!

Think yourself lucky - about a litre per 1000 miles is considered pretty normal for the TVR/Rover 5.0 litre V8!