lamba oxygen sensor
Author
Discussion

dave111s

Original Poster:

59 posts

242 months

Tuesday 26th September 2006
quotequote all
been have probs with my 111s latly when its warm it hunts for the tickover point and genraly donsnt feel well . trade a few things you guys surgested eventually got rond to running it with out the lamba conected and hay presto it all works fine again so i will get new sensor but is it ok to run it with out the sensor conected going away for the weekend realy wanted to take the elise
and all so i think a remember reading some where that some people have had problems with the elise ecu not handleing the upgrades they have done is that right thanks again to everyone that has helped me over the last few weeks

GreenV8S

31,027 posts

315 months

Tuesday 26th September 2006
quotequote all
Without the lambda sensor there's a danger that you will damage the cat.

stevie111s

123 posts

266 months

Thursday 28th September 2006
quotequote all
I think it is unlikely you will damage the cat, at least for a while, because the ECU will switch from closed loop to open loop control (i.e. it won't use the lambda sensor to influence fueling). What will happen is that an error code will be stored in the ECU, this could be read by diagnostics computer at a lotus/rover garage. I would recommend doing the work though. HTH.

GreenV8S

31,027 posts

315 months

Thursday 28th September 2006
quotequote all
stevie111s said:
I think it is unlikely you will damage the cat, at least for a while, because the ECU will switch from closed loop to open loop control (i.e. it won't use the lambda sensor to influence fueling).


That's why it will damage the cat. The purpose of the lambda sensor is to enable the ECU to maintain lambda=1 to protect the cat.

dave111s

Original Poster:

59 posts

242 months

Thursday 28th September 2006
quotequote all
thanks guys took out the sensor and gave it a clean will order a new one if that dont work decide not to go to far in it untill i know its ok thanks again

Arno

349 posts

309 months

Friday 29th September 2006
quotequote all
GreenV8S said:

That's why it will damage the cat. The purpose of the lambda sensor is to enable the ECU to maintain lambda=1 to protect the cat.


Should be no problem for the cat, really..

Even during open loop running most cars are mapped pretty close to lambda=1 in their tables. A tad richer normally to protect the engine, but still close.

Also.. An engine runs open loop quite a lot of the time. Only at steady-state running or very small changes in throttle position can it switch to closed loop.

Only if there's another problem acuaing a massively rich or lean mixture would you get into problems with the cat. Usually thermal problems..

Bye, Arno.