Clam Contruction Question
Discussion
The S2 uses pretty much no gelcoat at all, as these are not made using the old style method of putting woven glass mats in a shapen and putting resin onto them.
The S2 clams are made using an injection-moulding process using chopped glass stands in an epoxy, which is then injected under high pressure in stainless steel moulds.
This process results in a better resin-glass ratio (less resin), making it lighter, and also does not requie a gelcoat as the moulds used are ploshed smooth, so the resin does not 'stick' to them.
It's a little more difficult to repair because of this low resin content and short glassfibre strands, but traditional fibreglass repair methods do still work.
Bye, Arno.
The S2 clams are made using an injection-moulding process using chopped glass stands in an epoxy, which is then injected under high pressure in stainless steel moulds.
This process results in a better resin-glass ratio (less resin), making it lighter, and also does not requie a gelcoat as the moulds used are ploshed smooth, so the resin does not 'stick' to them.
It's a little more difficult to repair because of this low resin content and short glassfibre strands, but traditional fibreglass repair methods do still work.
Bye, Arno.
Arno said:
The S2 uses pretty much no gelcoat at all, as these are not made using the old style method of putting woven glass mats in a shapen and putting resin onto them.
The S2 clams are made using an injection-moulding process using chopped glass stands in an epoxy, which is then injected under high pressure in stainless steel moulds.
This process results in a better resin-glass ratio (less resin), making it lighter, and also does not requie a gelcoat as the moulds used are ploshed smooth, so the resin does not 'stick' to them.
It's a little more difficult to repair because of this low resin content and short glassfibre strands, but traditional fibreglass repair methods do still work.
Bye, Arno.
The S2 clams are made using an injection-moulding process using chopped glass stands in an epoxy, which is then injected under high pressure in stainless steel moulds.
This process results in a better resin-glass ratio (less resin), making it lighter, and also does not requie a gelcoat as the moulds used are ploshed smooth, so the resin does not 'stick' to them.
It's a little more difficult to repair because of this low resin content and short glassfibre strands, but traditional fibreglass repair methods do still work.
Bye, Arno.
Wow! Good info - thanks Arno
From what I recall being told at the factory, the S2 Exige clams are still hand laid.
My Exige clam is all scruffy & rough on the inside because of this, compared to the Elise which is nice & smooth.
The old clam that came off the front of mine (after a hare headbutted it), appeared to have an orange layer underneath the orange paint (not primer though) which i always assumed was the gelcoat. The new clam is green underneath the new paint - which doesn't really help with hiding the stone chips like the orange did!!
My Exige clam is all scruffy & rough on the inside because of this, compared to the Elise which is nice & smooth.
The old clam that came off the front of mine (after a hare headbutted it), appeared to have an orange layer underneath the orange paint (not primer though) which i always assumed was the gelcoat. The new clam is green underneath the new paint - which doesn't really help with hiding the stone chips like the orange did!!
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff



