griff needs new carpets
Discussion
Jason
Yes you do need to unbolt the rear section of the roof, it is just four bolts on the inside of the boot above the fuel tank area and a couple of screws on the inside and then i just taped it to the top bar, not that hard but just fiddley,
i used a good 3 to 4 cans of spay glue to put my carpet set in, probably the hardest bit of the job is doing the drivers footwell, it would probably pay to do a few lessons of yoga first,
and thats with the seats taken out.
like all jobs its the time, thought and the preparation that counts
martin
if you need to go through any thing you can pm me or i can give you my phone no
martin
Yes you do need to unbolt the rear section of the roof, it is just four bolts on the inside of the boot above the fuel tank area and a couple of screws on the inside and then i just taped it to the top bar, not that hard but just fiddley,
i used a good 3 to 4 cans of spay glue to put my carpet set in, probably the hardest bit of the job is doing the drivers footwell, it would probably pay to do a few lessons of yoga first,
and thats with the seats taken out. like all jobs its the time, thought and the preparation that counts
martin
if you need to go through any thing you can pm me or i can give you my phone no
martin
Edited by mf68 on Tuesday 24th October 13:12
Hi.it's up to you but i managed to fit carpets no problem with roof left on.Obviously removed pivot bolts,roof struts and the two screws visible both sides of pivot bolts.It's fiddly and you need to support roof in raised position but it's better than taking the roof off.Just leave enough carpet to tuck up underneath trim,there is plenty of room.......Good luck ......Simon.
Gassing Station | Griffith | Top of Page | What's New | My Stuff




