Cable route from dash to front of car?
Discussion
You should be able to see where most of the loom disappers into the wing about level with the top of the door (bottom of window). Its easier to pull through if you can remove the side repeater I found - still need to be a trick ladies doctor tho.
There is a grommet on the inner wing where the wiper motor harness is passed - but this is prone to leaks, if you want to go to the front of the car over the wheel arch in the wing is the better way.
Dave
There is a grommet on the inner wing where the wiper motor harness is passed - but this is prone to leaks, if you want to go to the front of the car over the wheel arch in the wing is the better way.
Dave
If you route it down the drivers side you can gain access by taking off the cover for the clutch resovoir. By using a flexible stiff cable (ie throttle cable) and feeding it back into the car you could tie your wire to it and then pull it back out, the cable can then be fed to the front and pulled through. Hope the explanation helps.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



