E34 "LOWER DOOR TRIMS"
Discussion
Hi, noticed i have a little rust scab on the bottom of one of my doors on my 1992 5-series
to get to it best, i need to remove the rubber trim section that runs the length of the bottom of the door (the earlier type one)..... anyone know if this can be re-used after removal, or if a new part has to be purchased? and any tips to remove/re-fit the trim? and ideas, advive would be more than appreciated..... thanks
Rich
to get to it best, i need to remove the rubber trim section that runs the length of the bottom of the door (the earlier type one)..... anyone know if this can be re-used after removal, or if a new part has to be purchased? and any tips to remove/re-fit the trim? and ideas, advive would be more than appreciated..... thanks
Rich
Looks like the just 'knock on'
www.realoem.com/bmw/showparts.do?model=HB52&mospid=47370&btnr=41_0733&hg=41&fg=40

www.realoem.com/bmw/showparts.do?model=HB52&mospid=47370&btnr=41_0733&hg=41&fg=40

eiger120 said:
Have you had any luck sourcing these? If so where and how much if you don't mind me asking - mine are looking rather tatty now but atleast since they fell off I can see there is no rust!!
Looks like not replies at all.Appears to be a common area to rust.
Not sure what the repair looks like, but talks about the strips often needing replacing sound like a pita? Spares appear to be running out, you can get about half of them (for std or m-tech) but at £60+ each from latvia and the like
Daniel
Found this thread, but sadly the images are long gone by the looks.
https://www.bimmerforums.com/forum/showthread.php?...
https://www.bimmerforums.com/forum/showthread.php?...
Gassing Station | BMW General | Top of Page | What's New | My Stuff


