Sagaris- cam sensor- wiring diagram

[VARLEYHYD]

Does anyone have wiring diagram for the Sagaris? Does the wiring loom cam sensor do anything, mine seems to be in fresh air?

[tail slide]

VARLEYHYD said:

Does anyone have wiring diagram for the Sagaris? Does the wiring loom cam sensor do anything, mine seems to be in fresh air?

Even dealers don't have diagrams... a TVR tradition

[targarama]

TVR used an engine loom from another car. There are a few knock sensor cables hanging around looking for something to do on top of the engine if that's what you've spotted. You'd think they could at least have tidied them away...

[VARLEYHYD]

Checked the loom out and it seems the unused cam sensor is just left loose and the water control valve is bundled up and tie wrapped to the heater pipe next to the alternator/ back of aircon pump.
If anyone is really keen i have a done a wiring termination list with cable/colour and plug ID's for both the engine looms. I did this when i traced a severed oil temp sensor wire fault, which was causing the change up lamps at 4000rpm
I wondered if i should cut back and blank off the unused plugs and wires, any comments appreicated

Edited by VARLEYHYD on Monday 5th March 21:15

[Tangoed]

Are they doing any harm! If not leave well alone. You never know in the future, you may need spare loom cables.

[VARLEYHYD]

Thanks Neil; I've left the wiring loom as is but tidied the dangling bits up out of the way with some heat shrink.Looks nice and tidy now