threaded bar - left and right handed.....
Discussion
Is it possible to buy threaded bar/rod that is threaded left on one end of the bar and right handed on the other end ?. It would need to be at least 1/2 inch diameter.
I want to start a subframe connector project and if i could find this it would simplify the design greatly.
thanks if you can point me towards any suppliers.
I want to start a subframe connector project and if i could find this it would simplify the design greatly.
thanks if you can point me towards any suppliers.
Edited by tpivette on Wednesday 21st March 15:25
I very much doubt you'll be able to buy half left and half right hand threaded bar.
Made myself a rear strut brace a couple of years ago by using two M16 bolts and welding the heads together then dressing it up which left a nice wide hex to turn with a spanner. One bolt had a right hand thread and the other a left hand thread. I then turned down and welded the corresponding nuts into the ends of tubes which were then attached to the rear strut towers via custom brackets.
Made myself a rear strut brace a couple of years ago by using two M16 bolts and welding the heads together then dressing it up which left a nice wide hex to turn with a spanner. One bolt had a right hand thread and the other a left hand thread. I then turned down and welded the corresponding nuts into the ends of tubes which were then attached to the rear strut towers via custom brackets.
Gassing Station | Suspension, Brakes & Tyres | Top of Page | What's New | My Stuff