how can I stop my accelerator "sticking"?
how can I stop my accelerator "sticking"?
Author
Discussion

lois22

Original Poster:

14,706 posts

283 months

Saturday 26th April 2003
quotequote all
I find that the accelerator on my smashing fiesta feels a bit stiff and if I go to press it lightly nothing happens until I increase the pressure and it jolts all the way down.

My mum refuses to accept that there is anything wrong but my sis agrees with me but wont say anything, what can I do to stop it doing this?

Ballistic Banana

14,706 posts

298 months

Saturday 26th April 2003
quotequote all

I find that the accelerator on my smashing fiesta feels a bit stiff and if I go to press it lightly nothing happens until I increase the pressure and it jolts all the way down.

My mum refuses to accept that there is anything wrong but my sis agrees with me but wont say anything, what can I do to stop it doing this?


Sounds like the cable is sticking somewhere or is the pedal getting caught on some loose carpet somewhere.

BB

Edited to say if it sundenly jolts down does the revs rise aswell, could be a Automatic choke problem if it has one.


>> Edited by Ballistic Banana on Saturday 26th April 12:09

Graham.J

5,420 posts

290 months

Saturday 26th April 2003
quotequote all
I'd go with cable sticking somewhere along it's path. Not much you can do I would'nt have thought bar taking it all apart and greasing it up.

tvrbob

11,197 posts

286 months

Saturday 26th April 2003
quotequote all
This is usually, but not always, the cable. Wire cable inside a sheath. To possible causes of sticking, one the inner cable is damaged, time to change it. Two it could be dry in which case it will have corroded a little. Find where the cable connects in the engine bay. You'll be able to oil between cable and sheath there. Work it in & out whilst applying oil. If this doesn’t work then it's a new cable needed.

deltaf

6,806 posts

284 months

Saturday 26th April 2003
quotequote all
Replace the cable, if its sticking, you could suddenly find it stuck ON...not good for your trousers!!!

lois22

Original Poster:

14,706 posts

283 months

Saturday 26th April 2003
quotequote all
so how do I pursuade my mum that it needs looking at! She swears it's fine for her!

planetdave

9,922 posts

284 months

Saturday 26th April 2003
quotequote all
Take the car out and come back in tears after a 'near miss' . Suggest handling onion/garlic onto eyelid, chillie on bits or pulling hairs inside pocket if u not volatile enuf

PatHeald

8,058 posts

287 months

Saturday 26th April 2003
quotequote all
I had a throttle stick wide open once (on the A6 at Chorley, just south of Preston).

Fortunately it was only an old Land Rover and I just turned the ignition off. (No servos, power steering or ignition locks to worry about)

The cable had snagged on something under the bonnet.

Not an experience to recommend, even in an old Landy.

Get your cable checked. If you can't do it yourself, then flutter your eyes at any suitably qualified bloke.

lois22

Original Poster:

14,706 posts

283 months

Saturday 26th April 2003
quotequote all
Well I have had a near miss cos of the dodgy breaks! The 1st half of the pressure pad does nothing! AGAIN she blames it on me but I've tried it out when I haven't 'needed' to break to see and the car didn't slow down with the break partly down...how can that NOT be a problem!

lois22

Original Poster:

14,706 posts

283 months

Saturday 26th April 2003
quotequote all

PatHeald said: I had a throttle stick wide open once (on the A6 at Chorley, just south of Preston).

Fortunately it was only an old Land Rover and I just turned the ignition off. (No servos, power steering or ignition locks to worry about)

The cable had snagged on something under the bonnet.

Not an experience to recommend, even in an old Landy.

Get your cable checked. If you can't do it yourself, then flutter your eyes at any suitably qualified bloke.


eek - sounds like what happened to all terrain in his landy. I think it was on the motorway though but he's always going up and down the A6!

Avocet

800 posts

286 months

Saturday 26th April 2003
quotequote all
Look under the bonnet while someone works the throttle. You might have to remove the air filter husing but you should see the other end of the cable moving. Grab the thing on the engine that the cable is pulling on and try to move it with your hand (without the engine running!) If it moves freely, the problem is probably the cable or pedal. If the arm that the cable pulls is still "sticky" the problem is at the engine end.

DennisTheMenace

15,605 posts

299 months

Saturday 26th April 2003
quotequote all

lois22 said: so how do I pursuade my mum that it needs looking at! She swears it's fine for her!


:shoutingfromaconcretebunker: women will always say its fine untill it fails , maintenance is an unheard of word to them , my mother for example has not had her citroen serviced for 20k (should be done every 6k)Have sort of it into her that service intervals should be stuck to , after all being a 1.9td it will eat a headgasket if not looked after and that'll cost her

deltaf

6,806 posts

284 months

Saturday 26th April 2003
quotequote all

PatHeald said: I had a throttle stick wide open once (on the A6 at Chorley, just south of Preston).

Fortunately it was only an old Land Rover and I just turned the ignition off. (No servos, power steering or ignition locks to worry about)

The cable had snagged on something under the bonnet.

Not an experience to recommend, even in an old Landy.

Get your cable checked. If you can't do it yourself, then flutter your eyes at any suitably qualified bloke.



Lol come flutter them at me...ill change it!

lois22

Original Poster:

14,706 posts

283 months

Sunday 27th April 2003
quotequote all

Avocet said: Look under the bonnet while someone works the throttle. You might have to remove the air filter husing but you should see the other end of the cable moving. Grab the thing on the engine that the cable is pulling on and try to move it with your hand (without the engine running!) If it moves freely, the problem is probably the cable or pedal. If the arm that the cable pulls is still "sticky" the problem is at the engine end.


Sounds impressive!!

I'll get those eyelashed fluttering! I'm clueless!