Do BP petrol pumps work properly?
Do BP petrol pumps work properly?
Author
Discussion

skittle

Original Poster:

312 posts

292 months

Wednesday 30th April 2003
quotequote all
Filling up the car at the local BP garage and it takes a bleeding age as the pump keeps on cuttin off as I try to fill her up.

Gush, click, gush, click etc

Now I tried pulling it out twisting it about and still no luck so I have to wait patiently whilst i fill up at the rate of a litre every 10secs

Anyone else have the same problem?

paolow

3,262 posts

289 months

Wednesday 30th April 2003
quotequote all
yes, BP pumps that i use either spill fuel, do it too slowly or just, as you say sit and click. dont know why but BP are by far the worst at managing the quality of the pumps. as a sidenote, did you know that on average the british motorist is overcharged 50p per year on miscalibrated pumps? interesting stuff eh?
time for bed methinks
...

edited because i cnat spell + also forgot to metion that shell seem much better generally at maintaining a sharp forecourt whereas esso especially is worse.




>> Edited by paolow on Wednesday 30th April 02:55

outlaw

1,893 posts

297 months

Wednesday 30th April 2003
quotequote all
now there an idear can we askem for a calibration cersificate every time we fill up.


ps dont worre i cant spell too LoL

kevinday

13,900 posts

311 months

Wednesday 30th April 2003
quotequote all
The pumps used by all petrol stations are supplied by varying companies, although they all work in much the same way. Maintainance is usually done by one of two specialist companies (well it was when I was in the trade) under contract.

If you have problems it is usually down to poor design by the car manufacturer, to check this use a different filling station to see if you still have the same problem. There may also be a variation in flow rate from one type of pump to another which may also have some effect.

Dr Jekyll

23,820 posts

292 months

Wednesday 30th April 2003
quotequote all
I have this problem on every pump when I fill my Peugeot 306. I even had the garage check my fuel tank vent but they ouldn't find a problem.

Is this normal for a 306?

markda

836 posts

289 months

Wednesday 30th April 2003
quotequote all

Filling up the car at the local BP garage and it takes a bleeding age as the pump keeps on cuttin off as I try to fill her up.

Gush, click, gush, click etc

Now I tried pulling it out twisting it about and still no luck so I have to wait patiently whilst i fill up at the rate of a litre every 10secs

Anyone else have the same problem?


Yes, bloody annoying as there one of the few petrol stations near me that sell SUL!

JohnL

1,766 posts

296 months

Wednesday 30th April 2003
quotequote all
Depends also on the tank filler neck design - Subarus are particularly bad for e.g. And on flow rate beign set too high.

Try pulling the lever up not all the way to get a lower flow rate - with a bit of trial and error you should get to the fastest flow rate possible without it cutting out.

Also if yoi tell the staff inside what's happened they can often get it sorted.

John_S4x4

1,364 posts

288 months

Wednesday 30th April 2003
quotequote all
I hate it when you just go click-stop-click at the pumps. I usually just bung in a fivers worth and go fill up else where later.
Am I right in saying that up in the pump nozzle there is a small tube inside, which leads to a sensor. This measures (petrol fumes) backpressure from the exiting air from your tank ? If the back pressure is at a certain level, then it stops the flow, as it reckons your tank is now full ?
Please correct me if I am wrong - Regards John S

Alan420

5,618 posts

289 months

Wednesday 30th April 2003
quotequote all

paolow said: as a sidenote, did you know that on average the british motorist is overcharged 50p per year on miscalibrated pumps?


Um, not at my old company (one of the big UK names). Weights and Meaures see to it. You are deep in the poo if your pumps fall out of tolerance limits, as a result we always set them in the customers favour.

As we hardly made any money on the fuel it was best not to attract trouble trying to dispense it.

Last year we reset them a bit less in the customers' favour, but they still are. We saved a fortune so I can understand how a smaller retailer may set them against customers.

JohnL

1,766 posts

296 months

Wednesday 30th April 2003
quotequote all

John_S4x4 said: Am I right in saying that up in the pump nozzle there is a small tube inside, which leads to a sensor. This measures (petrol fumes) backpressure from the exiting air from your tank ? If the back pressure is at a certain level, then it stops the flow, as it reckons your tank is now full ?


Correct.

And if the flow is going in too fast, then the speed and apparent pressure of the exiting air is too high, triggering the cut off. If the filler tube is too narrow, the velocity of the exiting air also increases with the same effect.

Which is why filling up more slowly works. You don't have to hold the pump lever hard against the stops, the speed varies according to how far in you press the lever. So relax the iron fist and you'll be OK!

pdV6

16,442 posts

292 months

Wednesday 30th April 2003
quotequote all
I too have this problem with BP pumps. Absolute nightmare. In order to fill up I have to dribble the fuel in so slowly it takes much longer than at other filling stations.

Saying that, I try to avoid the local BP as it only has 95RON UL.

Whilst whinging about BP, I can never get their air hoses to pump up my tyres either. Had an argument with the attendant one day which boiled down to her saying "you must be doing it wrong" and refusing to give me my 20p back! Sorry, but I have blown up a tyre or two in my time.

planetdave

9,922 posts

284 months

Wednesday 30th April 2003
quotequote all
All pretty much caused by narrow necks to stop you putting leaded in. LRP does not choke the cat so WTF they still doing it?

pdV6

16,442 posts

292 months

Wednesday 30th April 2003
quotequote all

planetdave said: All pretty much caused by narrow necks to stop you putting leaded in.

Nah - its just BP. Esso, Shell etc are all ok and my fuel filler is the same diameter at all these places!

se6b

1,306 posts

289 months

Wednesday 30th April 2003
quotequote all
Try filling a 90 litre tank with that feckin clickety-click clickety-click...drives me insane!!!

pdV6

16,442 posts

292 months

Wednesday 30th April 2003
quotequote all
Whilst we're on the subject, what happened to the nozzles which used to have the little catch on them, so you could lock the fuel flow on and leave it to click off when full?

Makes my back hurt bending down to hold the damn trigger!

paolow

3,262 posts

289 months

Wednesday 30th April 2003
quotequote all
- snippet of information on how pumps work...

www.newscientist.com/lastword/article.jsp?id=lw512

pdV6

16,442 posts

292 months

Wednesday 30th April 2003
quotequote all
Cheers Paolo, but I think the issue is not "how do petrol pumps work" (I think most people here have that covered ), but more "why is it that BP are so cr4p at setting up their pumps?"

JohnL

1,766 posts

296 months

Wednesday 30th April 2003
quotequote all

pdV6 said: Whilst we're on the subject, what happened to the nozzles which used to have the little catch on them, so you could lock the fuel flow on and leave it to click off when full?

Makes my back hurt bending down to hold the damn trigger!


Good point, they were always handy. Meant you could take a few steps away from the unburnt benzene leaking out as well

Marshy

2,751 posts

315 months

Wednesday 30th April 2003
quotequote all

pdV6 said: Whilst we're on the subject, what happened to the nozzles which used to have the little catch on them, so you could lock the fuel flow on and leave it to click off when full?


Look carefully and you'll find that the latch is still present (on the rear end of the trigger you pull), but the two metal bars that it would latch onto aren't present in the handle.

I keep meaning to put a small stiff bit of metal on my keyring so I can poke it through the hole and make myself a handsfree petrol nozzle. Keep forgetting...

pdV6

16,442 posts

292 months

Thursday 1st May 2003
quotequote all
Top plan!