cylinder head bolt sequence?

[bhpjon]

Evening all, does anyone have the correct sequence for undoing / redoing the cylinder head bolts please?

[GreenV8S]

Diagonally, starting from the centre and working out. 65-70 lb-ft, remember if you have the heads with three rows of bolts the outer row (nearest the exhaust) should be left loose to the very end and then just pinched up not fully torqued.

[bhpjon]

GreenV8S said:

Diagonally, starting from the centre and working out. 65-70 lb-ft, remember if you have the heads with three rows of bolts the outer row (nearest the exhaust) should be left loose to the very end and then just pinched up not fully torqued.

thanks, So for undoing, do i undo the centre two, then one to the lower left and diagonally one to the right, then the left upper and right lower etc?

[chrispitman]

Found this the other day www.landrover.ee/est/varia/downloads/engine.htm has all the landrover manuals in pdf gives complete strip down procedure and also all troque setting.

[bhpjon]

chrispitman said:

Found this the other day www.landrover.ee/est/varia/downloads/engine.htm has all the landrover manuals in pdf gives complete strip down procedure and also all troque setting.

Fantastic Chris! What a find! Thanks for your help, now i can get on!

[spend]

I've mentioned it before... I am not sure it too prudent to leave that link posted, not sure that the Estonians are within copyright

Dave

[Pasco]

spend said:

I've mentioned it before... I am not sure it too prudent to leave that link posted, not sure that the Estonians are within copyright

Dave

Grab it while you can guys

[spend]

Grabbed it all over 2 years ago.... Was'nt sure if it was going to last then...

Dave

[Pasco]

spend said:

Grabbed it all over 2 years ago.... Was'nt sure if it was going to last then...

Dave

Dave are you near B.O.T ?