S2 tyres: AD07 vs Bridgestone back to back comparison
S2 tyres: AD07 vs Bridgestone back to back comparison
Author
Discussion

shangani

Original Poster:

3,069 posts

268 months

Friday 20th April 2007
quotequote all
Initial thoughts after putting on AD07's. I have driven around 170 miles doing various things today, some on bridgestones and about 140 miles on the new AD07 tyres, as recommended by many people on here. Admittedly the AD07's need to be bedded in, but I did work off the coating fairly early on.

My impressions after using both on the same car on the same day:

1) Good grip on the AD07's, but not much different to the Bridgestones really. Grip a bit better than the bridgestones when cold, but with a little heat in the, both are very similar - on dry roundabouts and tight corners.

2) Steering is much lighter on the yokos (bridgestones fronts still had 5+mm tread, so unlikely to be wear related) This light steering feel was especially apparent at low speeds.

3) Steering feel is not as good as the bridgestones - so light as to be a bit vague when compared directly. Much prefer the feel of the bridgestones in this regard so far.

4) Not as much feel as the bridgestones under braking.

I will see how things feel after a few hundred miles. So far I would have to say that people have wrongly maligned the bridgestones. Unless these really improve a lot, I see the yoko's as being better in some areas - dry grip, but worse in others - less feel on steering / braking / cornering, less durability, higher cost.

More feedback after I use them in the wet and play around with tyre pressures.


Edited by shangani on Friday 20th April 10:14

S works

10,166 posts

281 months

Friday 20th April 2007
quotequote all
What pressures are you running? The Advan Neova's in the S1 sizes were always better when run a little below recommended pressure.

shangani

Original Poster:

3,069 posts

268 months

Friday 20th April 2007
quotequote all
26F 27R. I ran the bridgestones 26 all round as the rears were VX220 spec CFE dot code with a stiffer sidewall & same compound.

Gooby

9,269 posts

265 months

Friday 20th April 2007
quotequote all
I would have to heartily disagree. I have found the only "negative" with the ADO7 is the fact that they tram line a lot more than the bridgestones.

The bridgestones break grip under far less stress and in the wet they are an absolute nightmare (by comparison). I have had no problems under braking but then 04 111R brakes are not renowned for thier tactility. The bridgestones break is not as predictable or catchable as the Yoko's.

shangani

Original Poster:

3,069 posts

268 months

Friday 20th April 2007
quotequote all
Amongst others, Walshy has made the same comments about braking feel. I didn't say outright braking ability, but then the 111r brakes haven't got any feel anyway.

I haven't used them in the wet yet, but comparing knackered tyres to new ones isn't a fair comparison. I expected them to be better for the money etc and frankly I should probably have just replaced the worn out bridgestone rears.

As for breakaway - I found the bridgestones so predictable I would regularly have a play on roundabouts. The bridgestones do squeal more though. I am not saying the bridgestones are grippier - just that the car has lost a bit of its communication.


Edited by shangani on Friday 20th April 08:15

S works

10,166 posts

281 months

Friday 20th April 2007
quotequote all
shangani said:
26F 27R. I ran the bridgestones 26 all round as the rears were VX220 spec CFE dot code with a stiffer sidewall & same compound.

At a guess, try running a couple of PSI lower and see if that makes a diff.

Grinzzz

566 posts

248 months

Friday 20th April 2007
quotequote all
Sounds like the pressures are way too high. I found 23-24F 25-26R to be somewhere close to ideal. Any higher and the tyre was crowning and wearing in the centre.

Davislove

2,295 posts

277 months

Friday 20th April 2007
quotequote all
interesting post............Shang, what suspension / Geo / pressures are you running for reference?

4pot

481 posts

255 months

Friday 20th April 2007
quotequote all
I'm running 22.5F & 23.5R on my AD07's.

shangani

Original Poster:

3,069 posts

268 months

Friday 20th April 2007
quotequote all
I have reduced pressures to 24F 25R. I am running nitrons with 400/475 springs and an adjustable ARB currently 2 times stiffer.

GEO:
Front Castor +3.8
Front Camber -0.8
Front toe 0.5mm out TOTAL

Rear Camber -2.2
Rear toe 2mm in EACH SIDE

I agree the tyres seem grippy enough, I just realise the steering and braking would feel so different. I am sure I will see the real merits in the wet, particularly as my rear bridgestones were knackered and had very little rip in the wet of late. They were fun on roundabouts though.

Gooby

9,269 posts

265 months

Wednesday 13th June 2007
quotequote all
When I first started using the AD07's I had a standard suspension set up, now I have a very agressive suspension profile and Ohlins.

I would have to agree with shangani that in the wet the AD07's dont feel great. I think this tyre is sensitive to suspension geometry. In the dry they are astounding but in the wet they are likely to slide. (nice and progressive - damn good fun and at low speed)