machining front upright for added negative camber
machining front upright for added negative camber
Author
Discussion

k wright

Original Poster:

1,039 posts

290 months

Thursday 26th April 2007
quotequote all
Has anyone here performed this? My plan is to remove enough material from the steel front upright to allow 2 degrees of negative camber. With all of my spacers and bracket removed I'm still at less then 1 degree on my Exige S.

I would greatly appreciate speifics.

Thanks,

Ken Wright

bogie

17,108 posts

303 months

Thursday 26th April 2007
quotequote all
not personally, but quite a few people have on the S2, try SELOC if you need instructions

are you going to be running slicks then ?

hbaumhardt

950 posts

310 months

Thursday 26th April 2007
quotequote all
I did this for racing. -0.8 left -1.5 right is the best I could get with all shims out and wanted around 340R track settings at -1.7. You can either machine the upright/hub carrier or the ball joint plynth on the upper wishbone. I did the latter cos its easier to remove and get to a machine shop. At 0.25 degrees per mm I took 3 mmm off to give me up to -1.55.

Scuffers

20,887 posts

305 months

Thursday 26th April 2007
quotequote all
done this a few times...

rule of thumb, limit yourself to ~3mm max and make sure that it's done 100% flat and square.

k wright

Original Poster:

1,039 posts

290 months

Thursday 26th April 2007
quotequote all
Thanks very much for the information.

ken