Immobiliser problem and snapped boot release
Discussion
I can't start my car (S1 + Cobra). I was driving it earlier but had to come back home to collect something, after returning to my car it wouldn't start. It had similar symptoms to when the immobiliser has been been armed - everything works with the exception of the starter; when turning the key I can hear something click in the engine bay but not sure what or where. I've tried: reseting the alarm with the key/wand, remove & replaced battery, removed & cleaned fuses, but nothing seems to work. It's as if the immobiliser is stuck on or disconnected from the alarm somehow.
I was going to try to check out the immobiliser bits near the engine, but my boot release cable has snapped, looks like it snapped at the boot end 'cos there's lots of cable. So, having read a few things I was going to try and gain access via wheel arch lining, but I can't remove my wheels 'cos the locking wheel nut removal thing is in the boot. I've tried to squeeze my arm through through the side of the lining but I can't feel any dangling wires or anything that would allow me to open the boot.
I have a feeling the cure for both of these problems is going to be at great expense via the local dealer. Although, before I call the dealer and throw my money at him I was wondering if anyone has any ideas of how to open the boot and/or sort the alarm/immobiliser problem out.
FWIW: The alarm was newly fitted just before I purchased the car.
I was going to try to check out the immobiliser bits near the engine, but my boot release cable has snapped, looks like it snapped at the boot end 'cos there's lots of cable. So, having read a few things I was going to try and gain access via wheel arch lining, but I can't remove my wheels 'cos the locking wheel nut removal thing is in the boot. I've tried to squeeze my arm through through the side of the lining but I can't feel any dangling wires or anything that would allow me to open the boot.
I have a feeling the cure for both of these problems is going to be at great expense via the local dealer. Although, before I call the dealer and throw my money at him I was wondering if anyone has any ideas of how to open the boot and/or sort the alarm/immobiliser problem out.
FWIW: The alarm was newly fitted just before I purchased the car.
Hmm sorry about your bad news. The using the wand deprogrammes existing remotes, so you'll need to relearn the remotes you've got. Can you not start it with the wand and have you read the alarm manual? (copy in the buyers guide thread)
It might also be worth checking the fuel pump inertia switch, but thats in the boot.
It might also be worth checking the fuel pump inertia switch, but thats in the boot.

Paul RN said:
Hmm sorry about your bad news. The using the wand deprogrammes existing remotes, so you'll need to relearn the remotes you've got.
I think the wand only deprograms if the ignition is on when it's inserted. With the ignition off it merely sets/unsets the alarm. That's how I've been using it anyway.
I just went to the car to try to find the alarm controller box, hoping to find a reset button on the back of it, and I thought I'd just try to start it just on the off chance. Well, guess what ... it started! First time! Very strange! Even the AA man earlier couldn't get it started. It's done this once before but last time it just started to work after being left for 30 mins. I think there might be a electrical problem somewhere.
Just need to sort out the boot now.
hmmmm. the click you suggest sounds like an electrical problem does the car try to crank at all?....I had a similar situation recently on my S1; the wire connecting the battery to the alternator had snapped and was only intermittently making contact and therefore charging. The alarm and imobiliser will obviously drain the charge from the battery. Is the electrical indication light glowing on the stack display? This indicates an electrical problem.
As for the boot access, I (again!) also had this problem recently with a week's worth of shopping stuck inside. You don't need to remove the driver's side rear wheel, instead; you should be able to squeeze your arm in between the top of the wheel and the wheelarch. Using your fingers, grope about, you should feel a rubber lip. Use a bit of force and you should be able to prise your fingers beneath. Say goodbye to your finger skin; you should then be able to locate the boot release cable. Give it a good yank (try pulling the wire angled back towards the driver's door to minimize the risk of snapping it again) and hopefully the boot should trigger.
Good luck!
As for the boot access, I (again!) also had this problem recently with a week's worth of shopping stuck inside. You don't need to remove the driver's side rear wheel, instead; you should be able to squeeze your arm in between the top of the wheel and the wheelarch. Using your fingers, grope about, you should feel a rubber lip. Use a bit of force and you should be able to prise your fingers beneath. Say goodbye to your finger skin; you should then be able to locate the boot release cable. Give it a good yank (try pulling the wire angled back towards the driver's door to minimize the risk of snapping it again) and hopefully the boot should trigger.
Good luck!
rob-ix said:
I was going to try to check out the immobiliser bits near the engine, but my boot release cable has snapped, looks like it snapped at the boot end 'cos there's lots of cable. So, having read a few things I was going to try and gain access via wheel arch lining, but I can't remove my wheels 'cos the locking wheel nut removal thing is in the boot. I've tried to squeeze my arm through through the side of the lining but I can't feel any dangling wires or anything that would allow me to open the boot.
Having re-read the above, another suggestion may be to try pushing the boot lid towards the rear window whilst wiggling the catch, perhaps with somebody else pulling on the release cable. (This was the solution to my sticking boot after I gave up on the shopping stuck inside and took it back to the dealer 2 days later) Literally released within 30 seconds. Rather annoying!

The clicking sounds like the starter motor may be going. This can happen intermittently, because starter motors tend to stick a little, and when you get back in the car, it rocks the wheels, so the cogs in the starter motor move, and unstick themselves.
Once you are in the engine bay (eventually), try starting the car. If no luck, give the starter motor a hefty whack with a fair sized hammer. Don't be scared. They are tough items.
If the car then stars, this may be your problem.
Had the same symptoms with my Range Rover. AA man just hit it and started straight away!!
Once you are in the engine bay (eventually), try starting the car. If no luck, give the starter motor a hefty whack with a fair sized hammer. Don't be scared. They are tough items.
If the car then stars, this may be your problem.
Had the same symptoms with my Range Rover. AA man just hit it and started straight away!!
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


