THROTTLE LINKAGE

[marcus1970]

Well, I might as well get a new one of these as well. Mine seems to be seized and a ba*tard to adjust finely/properly.

Any ideas on the part number or where I can source one from?

Cheers

MB

[marcus1970]

...or anyone had a seized one and managed to loosen it off?

MB

[diycerb]

Hi Marcus,

I made a new one for mine, used some aluminium round bar from B&Q, drilled and tapped both ends, one left handed and one right handed thread and screwed in a couple of small rose joints (rod ends)that I purchased off the internet. When I asked the price from TVR I think they wanted over £40 just for the alley rod. I think I made the lot for less than thirty.

Rich.

[killerscum01]

Or i have one of these left, you can have it for £35 delivered.
http://img117.imageshack.us/img117/14

[sonnylad]

killerscum01 said:

Or i have one of these left, you can have it for £35 delivered.
http://img117.imageshack.us/img117/14

I shall take it if marcus dont.

Russ

[SI-PEN]

killerscum01 said:

Or i have one of these left, you can have it for £35 delivered.
http://img117.imageshack.us/img117/14

This is for a 4.2 Cerbera, Marcus has a 4.5

[SI-PEN]

marcus1970 said:

Well, I might as well get a new one of these as well. Mine seems to be seized and a ba*tard to adjust finely/properly.

Any ideas on the part number or where I can source one from?

Cheers

MB

Marcus, speak to TVR power and tell them what you want. I just bought the ball and sockets for each end (4 quid each), my link rod was OK but they can possibly do the lot for you.

Remember one has a left hand thread!!!

[marcus1970]

killerscum01 said:

Or i have one of these left, you can have it for £35 delivered.
http://img117.imageshack.us/img117/14

Cheers Berkely. I would have snapped your hand off, but as Simon mentioned, mines a 4.5

Marcus

[sonnylad]

Killerscum01 YHM

Russ