Steaming like a kettle!
Steaming like a kettle!
Author
Discussion

nick francis

Original Poster:

858 posts

292 months

Wednesday 2nd May 2007
quotequote all
My Exige S done 1100 miles from new, on tickover its steaming from the radiator and it appears to have lost considerable water. Also front offside headlamp cluster is now fogged! Fans still havnt cut in at 95 degrees, I decided to switch off the motor at this stage to avoid damage.

Anybody else experienced this?
My problem is that I am booked to do a track day next week and wont have time to get back to the dealer

tricky 100

954 posts

273 months

Wednesday 2nd May 2007
quotequote all
Sounds pretty conclusive you have a leak in that corner , hose or rad . I wouldn't track it like that , higher temps and more pressure may cause it to blow completly . Would it be covered by warranty still if it was damaged on track .

mike9009

11,024 posts

274 months

Wednesday 2nd May 2007
quotequote all
Had you washed the car or left it out in the rain? Water can easily rest on the radiator and then evaporate off once you start moving and the rad heats up. Could also explain why the lights have misted up? This used to happen on my VX - not sure if this could happen on the Exige also??

Also the fan did not kick in until about 105 on the VX - it is a pressurised system and so the water does not boil until a much higher temp when under pressure.

Has the water level definitely dropped?

Just worth checking.

HTH Mike

nick francis

Original Poster:

858 posts

292 months

Wednesday 2nd May 2007
quotequote all
no possibility of the steam asa result of standing water, its been bone dry here for days!

I think its a loose hose or possibly a little hole, can't see where the steam exits the front part of the car, its forward of the removable panels.

mcdude

12 posts

249 months

Thursday 3rd May 2007
quotequote all
If it is a loose hose then it'd pop off quickly and you'd lose all your fluid so I don't think this is the case, because you'd notice all the green coolant on the ground! It could be a poor mating surface where the hose meets the rad though.

If is is a pin hole leak, make sure and keep your coolant topped up and get it checked ASAP

It could be a bit of morning dew on your rad - I've had this in the past. Because of the layout of the rad, it can look very dramatic as is evaporates.

Basically, keep an keen eye on your coolant bottle and if it goes low then you've got yourself a leak (allow for some expansion due to heat).

This is what warranties are for, if there is something wrong, insist that it is fixed.

Rad fan is set to 105 (as already said). But remeber if you have no coolant at all in your engine then you'd get no coolant reading at all.