400 se servo

[Limey 666]

can anyone tell me what it is from, Granada, Cortina, ?? thanks in advance.

[350zwelgje]

Could be Rover (SD1?) with necessary adaptations.
Have a non-pas 350i wedge, so could be barking up the trees here.

Rob

[jmorgan]

Mine went south at the garage when they were bleeding the system. Long story short, they used the info on the casting with girling to match a new part up. I can only assume they called Old Bob who had retired many years and said there was one up the attic under the pigeons nest?

Ops. Thought you were on about the brake servo?

Edited by jmorgan on Monday 14th May 10:33

[WolfgangJ]

Mine is Rover SD1.
The only difference that I have noticed is that the housing was in aluminium and that the steering rods must have been made for TVR.
I still have my LHD without steering rods left but the shipping to UK is probably quite much otherwise it is for free.
Regards
Wolfgang

[Limey 666]

WolfgangJ said:

Mine is Rover SD1.
The only difference that I have noticed is that the housing was in aluminium and that the steering rods must have been made for TVR.
I still have my LHD without steering rods left but the shipping to UK is probably quite much otherwise it is for free.
Regards
Wolfgang

Thanks for the replies,the servo is not for mine its for my mates 400, the funny thing is its just rotted in the bottom and broken in half, has anyone else heard of this happening??

[shpub]

Are you talking about the brake servo or the PAS here? I think there is a bit of language problem here.

The brake servo is made from steel which is why it can rust. Probably a unit from a Cortina/Granada but the key point is ensuring that it matches the brake master cylinder which is probably a Cortina unit.