Best way to run a wire from engine bay to dash?
Best way to run a wire from engine bay to dash?
Author
Discussion

21TonyK

Original Poster:

13,413 posts

240 months

Thursday 10th May 2007
quotequote all
Is there an existing hole I can use? I can see where the main loom comes through but really don't want to rip the seats and rear panels out if there is an easy way.

stevie111s

123 posts

266 months

Thursday 10th May 2007
quotequote all
I ran some wires underneath ... entering where the handbrake cable is and then running along the centre and up to the dash. Taking off both rear under-trays make it easy. HTH.

Esprit

6,373 posts

314 months

Thursday 10th May 2007
quotequote all
stevie111s said:
I ran some wires underneath ... entering where the handbrake cable is and then running along the centre and up to the dash. Taking off both rear under-trays make it easy. HTH.


BINGO

Alternatively, a slightly tidier way is to run it down the centre console and up through the rear bulkhead over the fuel tank and through the grommet where the main loom comes through, behind the LH speaker.I've got my Extra speaker cables following this route (bi-wired some rear tweeters in) and an iPod cable following the handbrake cable route (plug on this was too big to go through grommet without making a mess).

21TonyK

Original Poster:

13,413 posts

240 months

Thursday 10th May 2007
quotequote all
Cheers guys, copped out and drilled a hole in the end. All done now.