Hanging Revs
Author
Discussion

Chr1sG

Original Poster:

39 posts

235 months

Thursday 17th May 2007
quotequote all
Evening all,
Firsty let me apologise cause it seems all of my posts are based around problems!!
However my S1 is suffering from a rather bad case of hanging revs, normally around 3000rpm
I'll drop the clutch to change gears and it just hangs there.

Come on people solutions and sympathy please!!!!!!

Also a large get bent to the chav who dared to shout out "your cars s**t" as he drove past my parked beauty in Sandbanks.
Well pal at least I'm not in an E reg Fiesta thats more than likely your Mums, go get a job and stop wearing tracksuits as casual wear there, Kappa just isn't cool.

I hope you knock up your 14 year old girlfiend called Shazney and get jailed.
Muppet!

andy g bmth

5,132 posts

260 months

Friday 18th May 2007
quotequote all
I'll put money on it being the throttle body as the standard one is made of crappy plastic which warps slightly when it gets hot casuing it to get stuck. Blip the throttle to stop it

I remember mine doig this at a set of traffic lights but stuck at 5500 rpm which scared the hell out of me.

But a larger 52mm (iirc) aluminium one which i believe is called the sport 160, gets rid of the problem and makes i slightly freer revving as well.

Nothing too serious - don't worry

Andy

thegreenhell

24,475 posts

250 months

Friday 18th May 2007
quotequote all
Your sticking throttle is quite common and is most likely due to either having the crappy original plastic throttle body or a worn throttle pedal linkage bush. First check in your engine bay to see if you have the plastic (black) or alloy (silver) throttle body. If it's the alloy one then it's probably the throttle pedal linkage playing up. If you have a plastic TB then it could be caused by either.

The plastic TB can be replaced with an alloy one:
www.eliseparts.com/shop/index.php?main_page=product_info&products_id=238

The pedal linkage can be fixed with an uprated linkage:
www.eliseparts.com/shop/index.php?main_page=product_info&cPath=162&products_id=607

alicrozier

562 posts

268 months

Friday 18th May 2007
quotequote all
Can also be a sticky IACV (Idle Air Control Valve).
Could also show as hesitation in light on/off throttle.




Edited by alicrozier on Friday 18th May 09:24

stevie111s

123 posts

266 months

Friday 18th May 2007
quotequote all
I don't think the IAC valve, even if stuck fully open, would raise rpm to 3000!

alicrozier

562 posts

268 months

Friday 18th May 2007
quotequote all
stevie111s said:
I don't think the IAC valve, even if stuck fully open, would raise rpm to 3000!


The issue I've experienced is the sticky IACV (stuck closed in this case) causes a vacuum in the manifold and as the throttle butterfly trys to close it sticks slightly open, just off it's seat. Even this very small opening can give 4-5K rpm on no load.

I had this on an S2 111S so ally throttle.

The throttle would only stick (when operated manually from the engine bay) with the engine running.

Problem cured with some carb cleaner in the IACV and functioned a few times (ignition on and off).

M7RT V

428 posts

289 months

Friday 18th May 2007
quotequote all
Chr1sG said:
Evening all,
Firsty let me apologise cause it seems all of my posts are based around problems!!
However my S1 is suffering from a rather bad case of hanging revs, normally around 3000rpm
I'll drop the clutch to change gears and it just hangs there.

Come on people solutions and sympathy please!!!!!!

Also a large get bent to the chav who dared to shout out "your cars s**t" as he drove past my parked beauty in Sandbanks.
Well pal at least I'm not in an E reg Fiesta thats more than likely your Mums, go get a job and stop wearing tracksuits as casual wear there, Kappa just isn't cool.

I hope you knock up your 14 year old girlfiend called Shazney and get jailed.
Muppet!


Pop it back into Westovers mate, let them sort it out!

S Works

10,166 posts

281 months

Friday 18th May 2007
quotequote all
As above, check TB first, then have IACV cleaned out.

jonbrydges

199 posts

242 months

Friday 18th May 2007
quotequote all
Try turning the car off, turning it to the 2 position so the dash lights come on but don't turn the engine over. Press the throttle pedal all the way down 5 times, then turn the engine on and go for a run to see if it stays on.

This seems to sort these typoe of problems where the sensors get confused.