sounds like my S1 is not firing on all 4 cylinders...why?
Discussion
hi chaps, I have recently noticed (ie from yesterday morning) that my Elise under anything more than the most feather light of feather light touches of acceleration is firing only on 3 cylinders...
why could this be?
it idles on all 4, but as soon as you pull away from a junction or similar it goes in to 3 cylinder mode...I feel like throwing the god damn thing away it's so irritating!
when this used to happen on my old mini it was always as a result of water on the dizzy or spark plugs, could it be the same on the Elise? I did wash the car on sunday....
I unscrewed the case that covers the spark plugs and left it off overnight (the car lives on the drive) to dry out but no joy, if anything it was worse this morning
is my diagnosis correct guys?
thanks.
why could this be?
it idles on all 4, but as soon as you pull away from a junction or similar it goes in to 3 cylinder mode...I feel like throwing the god damn thing away it's so irritating!
when this used to happen on my old mini it was always as a result of water on the dizzy or spark plugs, could it be the same on the Elise? I did wash the car on sunday....
I unscrewed the case that covers the spark plugs and left it off overnight (the car lives on the drive) to dry out but no joy, if anything it was worse this morning

is my diagnosis correct guys?
thanks.
Sounds like water in the spark plug wells. There's no point just taking the cover off, they could collect more condensation overnight. Get a nice wad of kitchen roll, fold it so it's long & thin and stuff it down around the spark plugs to see if there is any moisture in there. Chances are it'll be in the plug well 2nd from left. If this is the case then simply dry it out as much as you can.
You can stop this happening by running some silicone sealant along the edges of the spark plug cover strip so it's sealed in - but it's a relatively minor things so don't thin I'd bother.
You can stop this happening by running some silicone sealant along the edges of the spark plug cover strip so it's sealed in - but it's a relatively minor things so don't thin I'd bother.
erm, I'd have a go at getting rid of the water before removing the plug. If you take the plug out and there is water in there, its going straight into your engine, which isn't good.
You could try taking the cover off and going for a long drive. The hot temperature and increased airflow should shift most of it. Then give the plug leads a reseating when the engines cooled down a bit.
You could try taking the cover off and going for a long drive. The hot temperature and increased airflow should shift most of it. Then give the plug leads a reseating when the engines cooled down a bit.

right, turns out after having taken apart the ignition setup a best I could and cleaned/WD-40'd it...that it made no difference.
I happened to fill up with petrol from the local Total garage (had 17 litres in, filled it to 30odd) and...problem gone. completely.
so, dodgy petrol was to blame

oh well, at least I know whom not to use in future.
thanks for all your help people!
Tom
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff





