lambda....mot failure
lambda....mot failure
Author
Discussion

peter2704

Original Poster:

237 posts

239 months

Monday 28th May 2007
quotequote all
took wifes k series car to mot and it failed on emissions,lambda reading out should be betwwen .9-1.1 hers read 1.2 ,is it defo lambda or could it be something else ? how hard to remove if it is lambda?
cheers
peter

shangani

3,069 posts

268 months

Monday 28th May 2007
quotequote all
Is the Mil light on? Very easy to change the lambda sensors. You need a big spanner - was a 22 or 24 iirc. Is it an S1 or an S2? On the S2 there are 2 lambda sensors - pre and post cat. (I am not certain about the S1) Could also be that the CAT is fooked. However, it is always worth giving the car some beans and getting it properly warm before they do the test. That works for many people.

You need to jack the car up and remove the rear undertray (no need to remove the diffuser). The lambda sensors are easy to spot - on the CAT and on the manifold link pipe near the bottom front of the engine.

peter2704

Original Poster:

237 posts

239 months

Monday 28th May 2007
quotequote all
s1 ,..if cat fooked wouldnt that give a different reading,hc or oc?i have also heard they can be tight to get out

shangani

3,069 posts

268 months

Monday 28th May 2007
quotequote all
Mine were really easy - whole job took 45 min including undertrays. If the CAT has gone, it would still fail the MoT. Might be worth posting on Seloc for the techno gurus to mull over.

twistedsanity

493 posts

269 months

Monday 28th May 2007
quotequote all
?, the info from the garage means your emissions were incorrect, this isn't nessecarily your lambda sensor, im not familiar with exige's but it could just be a dirty air filter or something less sinister, i would put it on an obd tester or equivalent, if the lambda sensor is faulty it should throw up a code on the reader

jondude

2,441 posts

248 months

Monday 28th May 2007
quotequote all
Agree with above - I think the lambda sensor is the one which softens the mixture of exhaust gasses with air, dilutes them, if you like.

If you have old plugs, old oil and in particular a dirty air filter or holed exhaust, this can play havoc with the sensor. The dirty plugs or filter will make the gasses too rich and full of carbon, the holed exhaust can have the opposite effect, and both throw the lambda into overdrive.

GreenV8S

31,027 posts

315 months

Monday 28th May 2007
quotequote all
jondude said:
I think the lambda sensor is the one which softens the mixture of exhaust gasses with air, dilutes them, if you like.
I've never heard it described quite like that before! The lambda sensor determines the oxygen concentration in the exhaust gasses. It doesn't directly change the exhaust gasses, but it provides a signal to the ECU which enables the ECU to trim the fuelling to maintain the desired air/fuel ratio. If the lambda sensor is faulty then the ECU won't be able to maintain the mixture correctly. But there are plenty of other faults that can cause that too - you can't assume it's the lambda sensor at fault.