S1 coolant change - what do I need to know???
Discussion
Have decided to give this a go myself...how hard can it be??? 
This is what I think it involves:
Car on ramps, undertray off, remove cap, remove hoses and let drain. Hoses back on, car flat, coolant in chamber.
Start engine, cap still off,let thermostat open, bleed from engine, then rad bleed. Check the temperature does not fluctuate madly, cap on, check again, turn off, watch afternoon tennis.
That's it.
Or is it??? I can see Lotus talk about opening the bleeds before starting the engine, but as I cannot use a fancy circulator beyond the engine pumps, I take it that is a waste of time??
Any tips appreciated!!

This is what I think it involves:
Car on ramps, undertray off, remove cap, remove hoses and let drain. Hoses back on, car flat, coolant in chamber.
Start engine, cap still off,let thermostat open, bleed from engine, then rad bleed. Check the temperature does not fluctuate madly, cap on, check again, turn off, watch afternoon tennis.
That's it.
Or is it??? I can see Lotus talk about opening the bleeds before starting the engine, but as I cannot use a fancy circulator beyond the engine pumps, I take it that is a waste of time??
Any tips appreciated!!
Bleeding can be an 4rse. If you have an early s1, I believe the bleed point near the radiator is not the lowest point in the system making it difficult to get the air out.
Easier method is to run a hose from the return line at the header tank over the side of the car and point it into a drain, then just run the car. Keep topping up the header tank with clean water until the returns from the return hose are coming back clean. If you don't let the level drop out of the header tank, you can't introduce air to the system. Once you're happy the system is flushed continue the same way but top the system up with coolant instead of water till its all the way round. Easy.
Maybe not the official way but I can't see a downside and I've done it twice on my old car without problems...
Easier method is to run a hose from the return line at the header tank over the side of the car and point it into a drain, then just run the car. Keep topping up the header tank with clean water until the returns from the return hose are coming back clean. If you don't let the level drop out of the header tank, you can't introduce air to the system. Once you're happy the system is flushed continue the same way but top the system up with coolant instead of water till its all the way round. Easy.
Maybe not the official way but I can't see a downside and I've done it twice on my old car without problems...
Thanks for that - must admit, that sounds a clever and ingenious way to do it.
I always did think it made more sense to purge coolant, rather than drain, allow air in, then have the problem of getting rid of the air.
( Bit like changing the brake fluid - purging it is a million times easier than draining and then removing the air )
I'll read that advice again and seriously consider it!
I always did think it made more sense to purge coolant, rather than drain, allow air in, then have the problem of getting rid of the air.
( Bit like changing the brake fluid - purging it is a million times easier than draining and then removing the air )
I'll read that advice again and seriously consider it!
Gassing Station | Elise/Exige/Europa/340R | Top of Page | What's New | My Stuff


