Boot problem
Author
Discussion

Ultra Violent

Original Poster:

2,827 posts

300 months

Thursday 7th June 2007
quotequote all
Having just water cooled the pc (no leaks), I was running some benchmarking tests. These were at OC levels much less than I have run with just air cooling around 5-10% on a P4 3.3EE. I then OC'd the graphics card to max (as determined by its own tool, again I have run this with no probs before) and ran 3dmark03. Came back to see the pc had shut itself down. So restarted and went to set graphics card back to normal. Logged in fine, startup apps started loading then the mouse stopped working and the whole system hung. From there I have had problems getting it to boot. However if I leave the pc off for 10mins it will boot back in to windows but will again hang on loading start up apps with dead mouse etc...

Help

Oh, the only other thing that i did was to set the graphics card OC'ing to apply only to 3d apps. First time I have done that. Seems to boot fine in vga mode... So how do I update graphics driver in vga mode?

Edited by Ultra Violent on Thursday 7th June 14:23

Gateway Networks

89 posts

236 months

Thursday 7th June 2007
quotequote all
try pressing F8 during bootup and load into safe mode. have a fiddle from there.

Ultra Violent

Original Poster:

2,827 posts

300 months

Thursday 7th June 2007
quotequote all
yeah, did that worked fine... Just found a hairline crack in water block that had been dripping on to the back of the graphics card. No drips overnight when i tested the system with the motherboard "off". I guess the heat from the cpu opened the crack up and "drip, drip, drip".....