Clutch to floor
Author
Discussion

oswaldx

Original Poster:

19 posts

246 months

Saturday 9th June 2007
quotequote all
Clucth pedal is going to floor on 2001 S2 Elise - k series std 1800 - and can only just change gear. If you keep your foot on pedal for more than a few seconds, you loose the clutch altogether, and have to turn off engine, pump pedal a few times before you can get it out of gear.

Have blead the fluid through as the first (cheapest) option. No difference.

I assume there is no means of adjustment ?

There are no bubbles in fluid, and no signs of leaking - but read that the slave is prone to failure - could it be this ?

What is typical cost of getting new clutch fitted ?

Also, is it feasible that sohock absorbers (bilsteins) make a banging noise if worn out, when they are 'wram' as there is no noise for first few miles, then progresses to load banging/knocking over bumps.

Finally - just noticed a wisp of steam from radiator area - guessing it might be the crimped plastic end caps - or could it simply be a hose - only very slight at present - no noticeable coolant level drop, but worrying all the same.


boobles

15,251 posts

246 months

Saturday 9th June 2007
quotequote all
Steam from radiator, has it been raining by anychance?

ROB1979

221 posts

236 months

Sunday 10th June 2007
quotequote all
Replace the slave cylinder first,it costs about £40 from eliseparts. Is easy to do yourself and will probably fix it by the sound of the problem.
If it is the clutch it will be around £800 (that's what i paid) and go for the AP Racing one, it's a about 30 quid more but worth every penny.

Stu Hill

147 posts

247 months

Sunday 10th June 2007
quotequote all
Check the slave cylinder bracket too. These have been known to fail.

delS1

499 posts

271 months

Sunday 10th June 2007
quotequote all
Am I right in assuming an 01 S2 Elise has braded clutch pipes, do you get the probs with the clutch when hot?

oswaldx

Original Poster:

19 posts

246 months

Sunday 17th June 2007
quotequote all
better late than never - replaced seals in slave cylinder - very little difference. The bracket seems OK. If someone holds the clutch pedal down, whilst I hold my fingers against the slave pushrod, I can feel it slowly creeping back. This suggests fluid is creeping passed the seals somewhere. It is braided hoses, and happens hot or cold. There is no fluid dripping into footwell, but having looked at the cross section for the master cylinder, it seems possible that if the main seal is worn, then fluid can seep passed and return back into the pot. I'm hoping this is it anyway !

Will be ordering new master / seal kit in the morning.

If that doesn't sort it, it's off the garage for a new clutch .


oswaldx

Original Poster:

19 posts

246 months

Sunday 24th June 2007
quotequote all
All sorted - new clutch master made things fine - got a few twinges in the shoulders and back after trying to get the nuts back on - upside down in footwell, but got there in the end..biggrin

Suspension all seems fine.

Various littles tweaks here and there on other bits and bobs, and a full service. All running well. I didn't buy a dog after all.

Coolant is staying exactly at correct level and temp readings are spot on according to handbook.

A bit of a stutter when cold when applying a bit of throttle (I'm not wellying it!), maybe mixture etc - possibly the ECU water temp sensor ? Anyone shed light on this ?