New laptop can't be seen on home network
Discussion
Any help here, would be welcome. I have recently (yesterday) been given a new laptop, with (allegedly) the same software stack on it as my last one. However, unlike the old one, I cannot reach this one via the MS network from my other computers in the house. I can reach the other computers from this one, however.
I've tried disabling the firewall on my new laptop (Symantec) and on the other computers (Windows) but it doesn't seem to make any difference. This is very aggravating, as my laptop tends to be the home of the default printer for everyone in the house. It worked fine with my last laptop.
I've tried disabling the firewall on my new laptop (Symantec) and on the other computers (Windows) but it doesn't seem to make any difference. This is very aggravating, as my laptop tends to be the home of the default printer for everyone in the house. It worked fine with my last laptop.
Basic network check.
On the laptop that can't be seen, go > Start > Run > cmd (you're mileage will vary depending on WTF Vista does at this point). Type ipconfig.
You'll see a line called "IP Address", it should read something like 192.168.0.34 (if it's a 169 then that's the problem).
On another machine, do the same thing (run > cmd) and type:
ping <IP Address> so ping 192.168.0.34
This will do one of three things:
Report "Unknown host" or "no route to host" = double check the IP Address.
You will see "4 packets sent, 0 received, 100% lost" at the end of the run = Firewall is still working or the network card is shagged.
"4 packets sent, 4 received, 0% lost" = Basic network stuff is functioning.
If the basic network stuff is working, play around in Control Panel and make sure File & Printer sharing is turned on and that the firewall software is set to trust the 192.168.0.0/24 network.
On the laptop that can't be seen, go > Start > Run > cmd (you're mileage will vary depending on WTF Vista does at this point). Type ipconfig.
You'll see a line called "IP Address", it should read something like 192.168.0.34 (if it's a 169 then that's the problem).
On another machine, do the same thing (run > cmd) and type:
ping <IP Address> so ping 192.168.0.34
This will do one of three things:
Report "Unknown host" or "no route to host" = double check the IP Address.
You will see "4 packets sent, 0 received, 100% lost" at the end of the run = Firewall is still working or the network card is shagged.
"4 packets sent, 4 received, 0% lost" = Basic network stuff is functioning.
If the basic network stuff is working, play around in Control Panel and make sure File & Printer sharing is turned on and that the firewall software is set to trust the 192.168.0.0/24 network.
ThePassenger said:
Basic network check.
Thanks, I did all those things and none of them worked (well, sort of!) Eventually, I worked my way through the troubleshooter and discovered that the File and Print Sharing service was not loaded for network connections. Never seen that before, but that did fix it. Thanks to everyone for their suggestions.Gassing Station | Computers, Gadgets & Stuff | Top of Page | What's New | My Stuff



